We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of knit gloves with 3/4 foam nitrile coating and terry cloth insulation

BDG

BDG 99-9-265-10 Lined Nitrile Coated Gloves personal protective equipment

SKU CH-E86Q-BFJDC

Lined nitrile-coated knit gloves with terry cloth insulation, EN 388 4232X and EN 511 X2X ratings, 3/4 dip coverage for general-purpose hand protection

  • Terry-cloth lining keeps hands warm in cold conditions
  • 3/4-dip foam nitrile coating protects palms and fingers while leaving the back breathable
  • EN 388 4232X rating confirms abrasion, tear, cut and puncture resistance
  • EN 511 X2X rating certifies protection against cold and water penetration
  • Knit acrylic construction fits both left and right hands for versatile use

What these gloves are and who they suit

These BDG knit gloves combine an acrylic shell with a terry-cloth lining and a 3/4-dip foam nitrile coating on the palm and fingers. They are sold as a single pair in new condition and carry EN 388 4232X and EN 511 X2X ratings. The ambidextrous design suits general-purpose tasks where insulation and grip are required.

What they upgrade from

The terry-cloth insulation and foam nitrile coating replace unlined knit gloves or flat-dipped alternatives that lack cold protection and abrasion resistance. The upgrade is worthwhile when work involves chilled environments or rough surfaces that wear out basic coatings quickly. The EN 388 4232X rating confirms measurable abrasion and tear performance.

What to verify on your current kit before ordering

Confirm that a 3/4-dip coating provides enough coverage for the liquids or debris you encounter, since the back of the hand remains uncoated. Check that the acrylic shell and terry lining meet any specific cut-resistance or needlestick requirements your risk assessment demands. Ensure the ambidextrous fit matches the hand sizes used on site.

Highlights

  • Terry-cloth lining keeps hands warm in cold conditions
  • 3/4-dip foam nitrile coating protects palms and fingers while leaving the back breathable
  • EN 388 4232X rating confirms abrasion, tear, cut and puncture resistance
  • EN 511 X2X rating certifies protection against cold and water penetration
  • Knit acrylic construction fits both left and right hands for versatile use

Specifications

BrandBDG

Questions about this item

Will the EN 388 4232X rating handle abrasive materials?

The EN 388 4232X rating gives level 4 abrasion resistance and level 2 cut resistance, so the nitrile coating resists rough surfaces well.

Do I just pull these on or is there a fastening step?

The knit wrist stretches over the hand; no straps or clips to close. The step people miss is smoothing the terry lining flat before the fingers go in.

When does the terry cloth insulation need replacing?

Replace the pair once the terry cloth compresses and no longer traps warm air, or when the foam nitrile coating wears through to the acrylic knit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.