We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of BDG cut-resistant gloves, grey knit with black nitrile palm coating, seamless dipped finish

BDG

BDG 99-1-9500-11 Cut-Resistant Coated Gloves, Cut Level A2, Dipped, Nitrile, Personal Protective Equipment

SKU CH-S9CG-003CY

Cut-resistant knit gloves with nitrile palm coating, ANSI/ISEA A2 cut protection and EN 388 4X43B rating for high dexterity and grip

  • ANSI/ISEA Cut Level A2 protects against light cut hazards
  • HPPE knit shell delivers high dexterity and grip
  • Nitrile palm coating resists abrasion and improves handling
  • EN 388 4X43B rating confirms mechanical protection
  • Meets ANSI/ISEA 105, EN 388 and EN 407 standards

BDG 99-1-9500-11 Cut-Resistant Gloves

These knit gloves meet ANSI/ISEA Cut Level A2 and EN 388 rating 4X43B for mechanical protection. They are built for workers who need reliable hand safety during general handling, assembly or light fabrication tasks. The seamless HPPE construction supports high dexterity and grip without bulky padding. Buyers who require higher cut ratings or specialised thermal insulation should look elsewhere.

Breathable Knit Construction and Coated Palm

The seamless HPPE knit allows air flow while the nitrile palm dip resists oils and improves wet grip. This combination keeps hands cooler and reduces sweat build-up during normal shifts. The lightweight design avoids the heat retention common with heavier leather or multi-layer alternatives. No electrical or chemical hazard ratings are claimed for this model.

Sustained Wear in Repetitive Handling

Under continuous use the dipped coating maintains its grip profile without rapid wear-through on the palm surface. The knit shell resists snagging and holds its shape through repeated flex cycles better than single-dipped entry-level gloves. EN 407 and EN 388 compliance confirms baseline durability for ongoing industrial routines. The pair is sold as a single unit without replacement liners.

Highlights

  • ANSI/ISEA Cut Level A2 protects against light cut hazards
  • HPPE knit shell delivers high dexterity and grip
  • Nitrile palm coating resists abrasion and improves handling
  • EN 388 4X43B rating confirms mechanical protection
  • Meets ANSI/ISEA 105, EN 388 and EN 407 standards

Specifications

BrandBDG

Questions about this item

How do I put on the BDG 99-1-9500-11 gloves so the nitrile dip covers the palm correctly?

Slide each hand into the seamless knit shell with the coated palm facing your fingers; the left-right design aligns the A2 cut-resistant layer over the palm without twisting.

When should I replace these A2 cut-resistant gloves based on the EN 388 4X43B abrasion rating?

Replace the pair once the HPPE knit shows visible wear through the nitrile dip or the 4X43B abrasion resistance no longer protects against rough surfaces.

At what point does heat resistance become the limiting factor during continuous handling of hot parts?

The EN 407 rating governs heat protection; sustained contact above the rated level will degrade the HPPE fibres before the nitrile coating fails.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.