Bazarc
Bazarc 5MP OV5647 Fisheye Camera 130° Adjustable Focus 3.3V IR Fill Light
A 5 MP fisheye camera with a 130° diagonal view, adjustable focus and a 3.3 V IR fill light for Raspberry Pi boards
- TypeOther
- 5 MP OV5647 sensor captures detailed 1080p video
- 130° fisheye diagonal view covers nearly twice the angle of a standard 72° lens
- Adjustable focal length lets you sharpen the image for any subject distance
- 3 V IR fill light brightens low-light scenes without extra wiring
- Four mounting holes secure the module firmly in fixed-position projects
Wide-angle fisheye camera for Raspberry Pi
This 5-megapixel OV5647 module adds a 130-degree diagonal field of view to any Raspberry Pi board. Adjustable focus lets you tune sharpness for the working distance. A 3.3 V IR fill-light connector supports low-light capture without extra wiring.
Upgrade from standard 72-degree lenses
The fisheye optic nearly doubles the horizontal coverage of a typical 72-degree module, useful for robotics, surveillance or immersive streaming. The jump is worth it when a single wide view replaces multiple narrow cameras or pan-tilt mechanisms.
Simple CSI installation with four mounting holes
The board plugs into the camera serial interface and secures with four screw holes for fixed positioning. Focus is adjusted by turning the lens barrel; over-tightening can strip the fine thread. Ensure the IR fill light is fed from a clean 3.3 V rail to avoid noise on the sensor.
Highlights
- 5 MP OV5647 sensor captures detailed 1080p video
- 130° fisheye diagonal view covers nearly twice the angle of a standard 72° lens
- Adjustable focal length lets you sharpen the image for any subject distance
- 3 V IR fill light brightens low-light scenes without extra wiring
- Four mounting holes secure the module firmly in fixed-position projects
Specifications
| Type | Other |
|---|
Questions about this item
What are the four screw holes on the Bazarc 5MP OV5647 Fisheye Camera used for?
The four screw holes allow the module to be fixed in position on a mounting surface or enclosure.
How do I connect the 3.3V external power supply and IR fill light to the camera module?
Apply a 3.3 V supply to the external power pins and use the light fill access pins to drive the infrared fill light; both interfaces are on the same board.
Will the adjustable focal length need periodic recalibration after installation?
The focal length is manually adjustable; once set for the working distance it holds position without scheduled recalibration.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



