Battery Powered Fan for Ryobi 18v Battery, Clip Fan with LED Light & 210° Adjustable, Industrial Cooling Fan
A cordless clip fan runs on Ryobi 18 V batteries, tilts 210° and includes an LED light with two brightness levels
- Voltage125VAC
- Hznot_applicable
- PhaseBattery Powered, 18 volts
- Amps10
- MaterialPlastic
- Horsepower10 @ 240V, 20@ 480V, 30@600V
- Cordless operation with any Ryobi 18V battery
- Two speed levels and two LED brightness settings
- 210° adjustable tilt for targeted airflow
- Strong clip mounts to desks, tent frames and more
- Portable tabletop design for jobsite, camping or garage use
Cordless Fan for Ryobi 18V System
This portable fan runs on Ryobi 18V batteries such as P102, P103, P104, P105, P107, P108, P109 and P190, sold separately. It targets jobsite workers, campers and anyone needing airflow away from mains power. The unit includes a built-in LED light with two brightness levels. Two speed settings let you match airflow to the task.
Battery Runtime Dictates Use Time
Operation stops when the installed battery depletes, so total run time depends entirely on the capacity of the pack you supply. No AC adapter or charging circuit is built into the fan itself. The 125 VAC rating shown in the data refers to other equipment and does not apply to this cordless model. Users must plan battery swaps for continuous cooling.
210° Tilt and Strong Clip Mount
The head rotates through 210 degrees in two planes, directing air precisely where needed. A large spring-loaded clamp grips desk edges, tent frames, treadmill rails or similar surfaces without shaking. The plastic housing keeps weight low for portable use. Lubricating the battery interface can ease installation for those with limited grip strength.
Highlights
- Cordless operation with any Ryobi 18V battery
- Two speed levels and two LED brightness settings
- 210° adjustable tilt for targeted airflow
- Strong clip mounts to desks, tent frames and more
- Portable tabletop design for jobsite, camping or garage use
Specifications
| Voltage | 125VAC |
|---|---|
| Hz | not_applicable |
| Phase | Battery Powered, 18 volts |
| Amps | 10 |
| Material | Plastic |
| Horsepower | 10 @ 240V, 20@ 480V, 30@600V |
| Mount Type | Tabletop Mount, Portable |
| Fan Type | table_fan |
Questions about this item
Should I pick the 18-volt clip fan or the 125-volt model?
This unit runs only on an 18-volt Ryobi battery; the 125 VAC figure is a spec limit, not a mains-powered version, so there is no separate voltage choice to make.
What does the 210-degree adjustable tilt actually give me on site?
The head rotates through 210° in both planes, letting you direct airflow at almost any angle while the strong clip holds the fan to tent poles, desk edges or treadmill frames without shaking.
Which battery standard does the fan use and what capacity does it support?
It accepts Ryobi 18-volt packs such as P102, P103, P104, P105, P107, P108, P109 and P190; runtime scales with the amp-hour rating of the pack you insert.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
