We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of red and black power distribution blocks with terminal screws and studs

Batianda

Batianda 2 in 1 accessory power distribution block 10 x #8 screws 6 x 5/16" studs 48V 250A pair red black

SKU CH-E5F5-0Z712

Pair of 48 V DC bus bars with ten #8 screw terminals and six 5/16" studs rated 250 A continuous

  • 10 #8 screws and 6 studs organise every cable
  • 250 A continuous capacity feeds heavy loads safely
  • Nickel-plated brass busbars cut resistance and resist corrosion
  • 48 V DC rating suits boat car and RV systems
  • Frosted cover and insulated base shield against shorts

Power Distribution Block

The Batianda 2 in 1 accessory is a pair of bus bars rated for 48VDC and 250A continuous current. Each block provides 10 #8 stainless steel terminal screws and 6 studs sized at 5/16 inch for secure cable termination. Nickel plated brass busbar plates deliver low resistance and corrosion protection in marine, automotive or RV electrical systems. An insulated nylon base and PC frosted cover guard against accidental short circuits.

Compatibility Check

Verify that your system voltage does not exceed 48VDC before installation. Ensure the total continuous load stays within the 250A rating for the entire connection. Each individual connection must not exceed 20A for periods under one minute. Confirm that your cable lugs match the #8 screw terminals and 5/16 inch stud dimensions for a reliable fit.

Thermals Noise Power

Nickel plated brass construction minimises resistive heating during normal operation at rated loads. The insulated nylon base and semi-transparent cover contain no moving parts, so the assembly runs silently. No active cooling is required because the bus bar design dissipates heat passively across the copper plates. Power draw is determined solely by the connected accessories, not by the block itself.

Highlights

  • 10 #8 screws and 6 studs organise every cable
  • 250 A continuous capacity feeds heavy loads safely
  • Nickel-plated brass busbars cut resistance and resist corrosion
  • 48 V DC rating suits boat car and RV systems
  • Frosted cover and insulated base shield against shorts

Specifications

No published specifications for this item yet.

Questions about this item

Does the pair include mounting hardware or must I supply my own bolts?

The set provides ten #8 stainless-steel terminal screws and six 5/16" studs with nylon nuts; no separate mounting bolts are included.

Should I use the 250 A rating or the 20 A per-connection limit for my load calculations?

Plan on 250 A total continuous across the whole block, but keep any single terminal under 20 A for short bursts under one minute.

Will the 9.7" x 1.4" x 2.1" block fit behind my RV battery compartment panel?

The unit measures 9.7 inches long, 1.4 inches wide and 2.1 inches high; compare those dimensions to your available clearance before ordering.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.