Batianda
Batianda 2 in 1 Accessories 100 ft Cat 7 Ethernet Cable
A 100 ft Cat 7 patch cable rated for 10 Gbps at 600 MHz with triple shielding and 23 AWG conductors for indoor or outdoor use
- 10 Gbps speed with 600 MHz bandwidth for fast data transfer
- Triple shielding with foil and braid reduces interference
- 23 AWG conductors give more stable transmission than 30 AWG
- Snagless RJ45 connectors protect locking tabs during repeated use
- 100 ft length rated for outdoor and direct burial installation
High-Speed Cat 7 Cable 100 ft
This Cat 7 Ethernet cable runs 100 ft and supports data rates up to 10 Gbps with 600 MHz bandwidth. The triple-shielded construction uses STP twisted pairs, double aluminium foil and an aluminium braid to reduce interference. A 23 AWG conductor diameter provides stable transmission over the full length.
Outdoor-Rated Build and Snagless RJ45
The jacket is rated for direct burial and withstands outdoor weather as well as indoor routing. Snagless boots protect the RJ45 locking tabs from damage during repeated insertions. Shielded connectors maintain the cable's screening through to the termination point.
Ready for Gaming and Secure Data Transfer
High bandwidth and low latency suit gaming, streaming and large file transfers. The full shielding envelope helps protect personal network information from eavesdropping on the wire. No additional tools or software are required for installation.
Highlights
- 10 Gbps speed with 600 MHz bandwidth for fast data transfer
- Triple shielding with foil and braid reduces interference
- 23 AWG conductors give more stable transmission than 30 AWG
- Snagless RJ45 connectors protect locking tabs during repeated use
- 100 ft length rated for outdoor and direct burial installation
Specifications
No published specifications for this item yet.
Questions about this item
What bandwidth and speed does the Cat 7 cable support?
The cable is rated for up to 600 MHz bandwidth and 10 Gbps data speed, matching Cat 7 performance for high-throughput networking.
What is the wire gauge and shielding construction?
It uses 23 AWG conductors with triple shielding: each twisted pair has a foil shield (STP), plus overall double aluminum foil and aluminum braid.
How do you avoid damaging the RJ45 locking tabs during installation?
The snagless connector design protects the tabs; press the release lever fully before pulling the plug out to prevent snapping after repeated insertions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



