Batianda
Batianda 1B 6 Pin Female to D-Tap Power Cable 30cm 2 in 1 accessory
A 30 cm power cable with a straight 1B 6-pin female connector on one end and a 2-pin male D-Tap on the other, continuity tested
- Powers Red cameras via D-Tap from 1B 6-pin source
- 30 cm length keeps rig tidy and balanced
- Dual-connector design links Ronin to Red Scarlet and Epic
- 100 % continuity testing confirms reliable signal path
- Lightweight build adds minimal mass to gimbal setup
Power Connection for Ronin and Red Cameras
This cable links a 1B 6-pin female port to a D-Tap male connector, letting operators run Ronin gimbals from Red Scarlet or Epic battery systems. It is built for cinematographers who need a reliable power bridge on set. The 30 cm length keeps the rig tidy without excess slack.
Sustained Reliability on Set
Each assembly is 100% continuity tested before it leaves the factory, so voltage drop stays consistent during long takes. The lightweight construction reduces strain on gimbal mounts while the straight 1B plug resists accidental disconnects when the camera moves. No signal degradation appears over repeated daily use.
Single-Camera Compatibility Decides Fit
The cable only serves setups that combine a Ronin gimbal with Red Scarlet or Epic bodies using a D-Tap power source. Operators running other gimbal brands, different Red models, or non-D-Tap batteries cannot use this link. Verify both connector types on your gear before ordering.
Highlights
- Powers Red cameras via D-Tap from 1B 6-pin source
- 30 cm length keeps rig tidy and balanced
- Dual-connector design links Ronin to Red Scarlet and Epic
- 100 % continuity testing confirms reliable signal path
- Lightweight build adds minimal mass to gimbal setup
Specifications
No published specifications for this item yet.
Questions about this item
Does the 30 cm cable add noticeable resistance or heat when powering a Red Weapon all day?
The 30 cm length keeps resistance low, and the 100 % continuity test confirms clean power delivery without extra heat.
What connectors must my rig already have for this 1B 6 pin female to D-Tap cable to work?
Your power source needs a 1B 6 pin male output and your camera or accessory must accept a 2 pin male D-Tap input.
Will this cable connect a Red Scarlet or Epic to an older Ronin gimbal that uses 1B 6 pin power?
Yes, the straight 1B 6 pin female plugs into the Ronin while the D-Tap male feeds the Red Scarlet or Epic directly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
