Batianda
Batianda 10G SFP+ BiDi Transceiver Pair 1270/1330nm 10-20km
A pair of 10 Gbps BiDi SFP+ transceivers for 10 to 20 km single-mode fibre links using 1270 nm and 1330 nm wavelengths
- 10 Gbps throughput over 10 to 20 km single-mode fibre
- Bidirectional 1270 nm and 1330 nm wavelengths on one LC port
- Hot-pluggable SFP+ MSA form factor for instant deployment
- Individually technician-tested for reliable interoperability
- Compatible with Cisco, Ubiquiti, Netgear, D-Link and other open switches
Pair of 10G SFP+ BiDi Transceivers
This pair provides two matched 10G SFP+ BiDi modules for single-fiber 10 Gigabit Ethernet links. Each transceiver uses opposite wavelengths so one unit transmits at 1270 nm and receives at 1330 nm while the other does the reverse. The set is built for network engineers and integrators deploying 10G uplinks between switches, routers, servers or NICs over single-mode fibre.
Reach and Interface Limits
The modules follow IEEE 802.3 ae and SFP+ MSA, delivering 10 Gb/s over OS2 single-mode fibre with LC connectors. Rated distance is 10 to 20 km depending on link budget and fibre quality. Operating temperature range is 0 to 70 °C. Only single-LC single-mode patch cords are supported; multimode fibre or dual-LC cables will not work.
Compatibility and Pre-Install Checks
Verify that each target port accepts SFP+ transceivers and is configured for 10GBase-LR or 10GBase-BX operation. Confirm the host vendor allows third-party modules or has a compatible coding profile. Ensure single-mode OS2 patch cables with LC connectors are available for the planned distance. Check that the switch or router firmware supports hot-pluggable BiDi optics at 10 Gb/s.
Highlights
- 10 Gbps throughput over 10 to 20 km single-mode fibre
- Bidirectional 1270 nm and 1330 nm wavelengths on one LC port
- Hot-pluggable SFP+ MSA form factor for instant deployment
- Individually technician-tested for reliable interoperability
- Compatible with Cisco, Ubiquiti, Netgear, D-Link and other open switches
Specifications
No published specifications for this item yet.
Questions about this item
Should I order the TX 1270 nm / RX 1330 nm module or the TX 1330 nm / RX 1270 nm module for my link?
The pair includes one of each wavelength combination; install the TX 1270 nm unit at one end and the TX 1330 nm unit at the other so the transmit and receive channels match across the single fibre.
What does the 10-20 km reach mean when the transceivers are installed in a live 10 GbE link?
The modules support up to 20 km over OS2 single-mode fibre at 10 Gb/s; actual distance depends on fibre quality, splice loss and connector cleanliness in your installation.
Does the SFP+ MSA and IEEE 802.3 ae compliance guarantee plug-and-play operation in my Cisco or Ubiquiti switch?
Yes, the transceivers follow the SFP+ MSA footprint and IEEE 802.3 ae standard, so they are hot-pluggable and recognised by Cisco, Ubiquiti UniFi and other listed vendors without extra configuration.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
