Batianda
Batianda 0B 2 Pin Right Angle to Straight Power Cable 30cm 2 in 1 accessory
Connects compatible cameras and monitors to battery packs or ARRI/RED DSMC2 sources using a 0B 2-pin right-angle to straight cable
- Powers monitors and cameras from battery packs
- 0B 2-pin male to male right-angle connector
- 30 cm flexible lightweight cable
- ARRI standard Pin1 ground Pin2 power wiring
- Compatible with Alexa DSMC2 and RED cameras
Purpose-built power cable
This 0B 2-pin right-angle to straight cable delivers power from battery packs or Alexa and RED DSMC2 cameras to monitors, receivers and cameras. It suits cinematographers and rental houses that need a reliable 30 cm link for on-set rigs.
Compact routing and wiring
The 90-degree elbow connector keeps the cable clear of tight camera cages while the flexible, lightweight wire resists snagging during handheld moves. ARRI-standard pinout assigns Pin 1 to ground and Pin 2 to power for consistent polarity.
Single-cable compatibility
One 30 cm assembly replaces two separate leads by combining right-angle and straight 0B FGG 2-pin male to FHG 2-pin male ends, so buyers needing separate cables for each device must look elsewhere.
Highlights
- Powers monitors and cameras from battery packs
- 0B 2-pin male to male right-angle connector
- 30 cm flexible lightweight cable
- ARRI standard Pin1 ground Pin2 power wiring
- Compatible with Alexa DSMC2 and RED cameras
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect the 0B 2-pin right-angle plug to my camera battery port without bending the cable?
Align the keyed 0B FGG male connector with the camera's 2-pin port, push straight in until it clicks, then route the 30 cm soft wire so the 90-degree elbow points away from the body to avoid strain.
Will the flexible wire insulation degrade if I coil this 30 cm cable daily for location shoots?
The lightweight jacket is rated for repeated flexing; inspect for cuts or exposed conductors after heavy use and replace the cable if the insulation shows cracking.
At what current draw does the 2-pin ARRI-wired cable hit its thermal limit during continuous powering of a monitor?
The 2-pin ARRI wiring (Pin1 Ground, Pin2 Power) handles typical monitor loads; sustained draws near the connector's rated capacity will warm the joints first, so monitor connector temperature during long takes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



