We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black AC adapter with mini 3-pin plug and long cable

BASEUS

BASEUS 18.5V 3-Pin AC Adapter for Behringer XENYX 502 802 1002

SKU CH-EKPY-XSK0N

Replacement 18.5 V AC adapter with 3-pin output powers Behringer XENYX and Q-series mixers from 110-120 V mains

  • TypeAC Adapters
  • Delivers 18.5 V AC power to run your Behringer XENYX mixer reliably
  • 500 mA output rating matches the mixer's original supply specification
  • Built-in overload, thermal, short-circuit and over-voltage protection keeps equipment safe
  • 4 ft total cable length gives flexible placement in studio or stage setups
  • Works with UB502, UB802, UB1002 and Q-series USB mixers for broad compatibility

Compatible mixers

This 18.5V AC adapter is built as a direct replacement for Behringer XENYX 502 802 1002 mixers and the UB Q series models listed. It accepts 110V to 120VAC input at 60Hz and delivers 18VAC x2 at 500mA through the required mini 3-pin connector.

Power capacity and limits

The 20VA output rating provides enough headroom for the supported mixer models under normal operation. Overload, thermal, short-circuit and overvoltage protections shut the unit down before damage occurs, so the adapter runs out of capacity only when a connected device draws more than the rated 500mA.

Cable reach and safety

A 3.9ft input cord and 6.5ft output cord combine to 10.4ft total length, letting you position the mixer away from the wall outlet. The built-in protective circuits reduce noise and interference, which helps maintain clean audio performance during sessions.

Highlights

  • Delivers 18.5 V AC power to run your Behringer XENYX mixer reliably
  • 500 mA output rating matches the mixer's original supply specification
  • Built-in overload, thermal, short-circuit and over-voltage protection keeps equipment safe
  • 4 ft total cable length gives flexible placement in studio or stage setups
  • Works with UB502, UB802, UB1002 and Q-series USB mixers for broad compatibility

Specifications

TypeAC Adapters

Questions about this item

Will this 18.5 V adapter power my older Behringer XENYX 502 mixer without modification?

Yes, the 18.5 V 500 mA output matches the XENYX 502 requirement and the mini 3-pin plug fits the mixer’s power socket directly.

How can I verify the adapter is delivering clean power to my UB802 after connecting it?

The mixer should power on without hum, the phantom power LED lights normally, and the overload protection stays inactive during use.

Does the package include both the 3.9 ft input cable and the 6.5 ft output cable, or must I supply one?

Both cables are permanently attached to the adapter, giving a total 10.5 ft reach with no extra purchase needed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.