Barco
Barco IQ G210L Single 120W projector lamp
A 120W UHP replacement lamp module with 4,000-hour life, supplied as a complete housing for straightforward Barco projector installation
- TypeUHP
- Wattage120W
- Lamp Life4,000 Hrs.
- Ready-to-install module saves setup time
- 120W UHP bulb delivers specified brightness
- 4000-hour rated life reduces replacement frequency
- OEM-compatible build matches Barco R9841771 fit
- ISO9001 manufacturing ensures consistent quality
Direct-fit replacement for Barco projectors
The Barco IQ G210L lamp module delivers a new 120 W UHP bulb inside a complete housing, ready to install in compatible Barco projectors. It is aimed at operators who need a straightforward swap without sourcing bare bulbs or separate cages. The unit matches the OEM part number R9841771.
Assembled housing simplifies maintenance
The lamp ships as a fully assembled bulb-and-housing unit, so there is no need to handle a bare burner or align a separate reflector. A 120 W UHP source is rated for 4,000 hours of operation, and each module is built to ISO 9001 quality checks covering ignition, voltage, beam performance and run-time.
Verify projector model and lamp hour counter
Before ordering, confirm that your projector accepts the IQ G210L designation and the R9841771 part number. Plan to reset the lamp-hour counter after installation so the projector tracks the new 4,000-hour rating correctly.
Highlights
- Ready-to-install module saves setup time
- 120W UHP bulb delivers specified brightness
- 4000-hour rated life reduces replacement frequency
- OEM-compatible build matches Barco R9841771 fit
- ISO9001 manufacturing ensures consistent quality
Specifications
| Brand | Barco |
|---|---|
| Type | UHP |
| Wattage | 120W |
| Lamp Life | 4,000 Hrs. |
Questions about this item
Does the 120 W UHP lamp reach the rated 4,000-hour life in normal use?
The lamp is rated for 4,000 hours; actual life depends on projector ventilation, usage patterns and power-cycle frequency.
Will this module fit my Barco projector without extra brackets?
The lamp ships as a complete bulb-and-housing assembly matched to Barco part R9841771, so it installs directly into the original lamp cage.
What is the correct way to seat the lamp module during installation?
Align the connector, press the module firmly until it clicks, then secure the retaining screw; skipping the screw can cause intermittent contact.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



