Baldwin 4'' x 12'' Industrial Cooling Fan 140 CFM 3600 RPM
A 10-by-12-inch register booster fan delivers 140 CFM at 3600 RPM with smart thermostat control, five speeds and a remote
- Air Flow140 cubic_feet_per_minute
- Motor RPM3600 rpm
- Fan RPM3600 rpm
- Hznot_applicable
- PhaseCorded Electric
- Mount TypeFlush Mount, Drop-In Installation
- Balances airflow in distant rooms with 140 CFM output
- Smart thermostat runs fan only when HVAC is active
- Dual ball-bearing motor keeps noise low at 3600 RPM
- Remote and onboard controls adjust 5 speeds without bending
- Flush-mount design fits 4 by 12 inch vent openings
Baldwin 4'' x 12'' Register Booster
The Baldwin 4'' x 12'' register booster fan delivers 140 CFM airflow at 3600 RPM to push heated or cooled air into rooms that stay too warm or too cold. It fits standard 4 by 12 inch floor, wall or ceiling registers and installs with a flush-mount, drop-in design. Homeowners with uneven temperatures across upstairs bedrooms or distant corners will notice more balanced comfort without forcing the central HVAC system to run longer cycles.
Check Register Size and Power Access
Measure the existing register opening to confirm it matches the 4'' x 12'' dimensions before ordering. The unit requires a nearby standard electrical outlet for its corded-electric power supply. Verify the mounting surface can support a flush installation and that the register grille can be removed for drop-in placement. No ductwork modifications or special wiring are needed.
Quiet Operation with Smart Thermostat
Dual ball-bearing motors keep mechanical noise low enough for bedrooms and nurseries while moving 140 CFM of air. The built-in temperature sensor activates the fan only when the HVAC system is blowing, so power draw stays minimal and the unit never runs idle. A display-off night mode removes LED light, and five speed settings let you match airflow to the room without audible distraction.
Highlights
- Balances airflow in distant rooms with 140 CFM output
- Smart thermostat runs fan only when HVAC is active
- Dual ball-bearing motor keeps noise low at 3600 RPM
- Remote and onboard controls adjust 5 speeds without bending
- Flush-mount design fits 4 by 12 inch vent openings
Specifications
| Brand | Baldwin |
|---|---|
| Air Flow | 140 cubic_feet_per_minute |
| Motor RPM | 3600 rpm |
| Fan RPM | 3600 rpm |
| Hz | not_applicable |
| Phase | Corded Electric |
| Mount Type | Flush Mount, Drop-In Installation |
| Fan Type | floor_fan |
Questions about this item
What comes in the box and does anything need to be bought separately?
The unit includes the 4'' x 12'' booster fan, a remote control, and onboard buttons for operation. It uses a corded electric connection so no batteries or additional wiring kits are required.
Should I choose the 4'' x 12'' or the 4'' x 10'' size?
Select the 4'' x 12'' model when your register opening measures twelve inches long; choose the 4'' x 10'' variant for a ten-inch opening. Both mount flush and install as drop-in units.
What does the 140 CFM airflow figure mean once the fan is installed?
At 140 cubic feet per minute the fan can push heated or cooled air farther into distant rooms, helping balance temperatures without forcing the HVAC system to run longer.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
