We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black rectangular converter unit with wiring harness and separate gain control knob

Axxess Technologies

Axxess AXLOC-FD2 2 Channel LOC Line Output Converter car electronics accessory

SKU CH-MX6G-FTX47

Converts factory speaker signals to two low-level RCA outputs for adding an amplifier to select Ford models from 2011 onward, with a gain controller and signal-sensing remote turn-on included

  • TypeLine Output Converter
  • Adds amplifier-ready RCA output from factory stereo
  • 55-watts per channel drives speakers or subwoofers
  • Adjustable gain controller sets precise output level
  • Signal-sense 12 V 500 mA remote wire powers on automatically
  • Fits select Ford models from 2011 through 2020

Two-Channel Line Output Converter

The Axxess AXLOC-FD2 converts factory speaker-level signals into two channels of low-level RCA output for select Ford vehicles from 2011 onward. It enables the addition of an aftermarket amplifier for speakers or a subwoofer without replacing the original radio. A separate gain controller lets you match the output level to your amplifier. The unit includes a 12-volt 500-milliamp remote turn-on wire triggered by signal sense.

55-Watt Per Channel Input Rating

This converter accepts up to 55 watts per channel from the factory speaker wires. That rating is the single specification that determines whether the unit can handle your vehicle's stock amplifier output without distortion or damage. Exceeding this limit will cause clipping and potential failure. Verify your factory system's per-channel power before installation.

Ford Model Coverage And Limitations

The harness fits Edge 2011-2020, Escape 2013-2019, Explorer 2011-2019, F-150 2013-2020, Super Duty 2017-2019, Fiesta 2011 onward, Focus 2012-2018, Fusion 2013-2019, Mustang 2015-2020, Ranger 2019-2020, Transit 2015-2019 and Transit Connect 2014-2018. It provides only two output channels, so builders needing front, rear and subwoofer zones require additional converters. An SPDT relay is recommended when driving multiple amplifiers from the single remote wire.

Highlights

  • Adds amplifier-ready RCA output from factory stereo
  • 55-watts per channel drives speakers or subwoofers
  • Adjustable gain controller sets precise output level
  • Signal-sense 12 V 500 mA remote wire powers on automatically
  • Fits select Ford models from 2011 through 2020

Specifications

TypeLine Output Converter

Questions about this item

What does the 55-watt per channel rating mean when I connect an amplifier?

The 55-watt per channel rating shows the maximum speaker-level signal the converter can accept from the factory radio before it distorts, so your amplifier receives a clean low-level signal up to that power level.

How does the 12v-500mA remote wire with signal sense work in practice?

The remote wire outputs 12 volts at up to 500 mA whenever the converter detects audio on the factory speaker wires, turning your amplifier on and off automatically without a separate switched power lead.

What space and mounting provisions does the Gain Controller need?

The separate Gain Controller is a small wired module that can be tucked under the dash or mounted with a single screw through its flange, requiring only a few centimetres of clearance for the knob and cable.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.