We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Axiom QSFP28 passive DAC cable with twin connectors, three metres long

Axiom

Axiom CPAC-DAC-100G-3M-AX 100G QSFP28 passive DAC fibre optic cable 3m

SKU CH-THH3-DXAST MPN CPAC-DAC-100G-3M-AX

Connects Check Point switches and routers at 100 Gbps using a 28 AWG passive twinax assembly

  • 100 Gbps throughput for high-density 100G QSFP28 links
  • Passive twinax design consumes no power and generates no heat
  • 3 metre reach suits rack-to-rack and adjacent-switch connections
  • Pre-coded for Check Point compatibility and MSA-compliant across vendors
  • Unique serialisation on each assembly prevents address conflicts in the fabric

100 Gbps QSFP28 passive DAC for Check Point gear

This three-metre twinax cable delivers 100 Gbps connectivity between switches and routers that accept QSFP28 modules. It is aimed at network engineers who need a cost-effective, short-reach link inside a rack or between adjacent racks. The cable arrives pre-coded for Check Point compatibility so it is recognised immediately by the host equipment. No external power or configuration is required.

Passive design keeps thermals and noise at zero

Because the assembly contains no active circuitry it draws negligible power and generates no heat of its own. There are no fans, pumps or electronic components that could produce audible noise during operation. The passive construction also means the link imposes no additional thermal load on the surrounding equipment. Power consumption remains limited to the port electronics on each end.

MSA-compliant QSFP28 connectors ensure broad

Each end terminates in a standard QSFP28 plug that meets the multi-sourcing agreement for mechanical and electrical fit. Serialised part numbers eliminate identification conflicts when multiple cables are deployed in the same chassis. The rugged twinax jacket resists bending stress during routine patching and cable-management tasks. Compatibility extends to any MSA-compliant platform beyond the original Check Point environment.

Highlights

  • 100 Gbps throughput for high-density 100G QSFP28 links
  • Passive twinax design consumes no power and generates no heat
  • 3 metre reach suits rack-to-rack and adjacent-switch connections
  • Pre-coded for Check Point compatibility and MSA-compliant across vendors
  • Unique serialisation on each assembly prevents address conflicts in the fabric

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the QSFP28 connectors on this 100G passive DAC, and what step do people often miss?

Align each QSFP28 module with the switch port, push straight in until the latch clicks, then verify the link light; the step most often missed is forgetting to remove the protective dust caps before insertion.

What maintenance or replacement will this 3-metre twinax cable need over time?

Passive twinax cables have no active components, so they require no firmware updates or scheduled replacement; only inspect the connector ends for dust or bent pins if link errors appear.

What is the first limit that appears when this 100G DAC runs at full throughput continuously?

The 3-metre passive design is rated for 100GBASE-CR4; the first practical limit is signal attenuation beyond the specified reach, which can cause bit errors if the cable is extended or bent tightly.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.