Axiom
Axiom AXG97440 10GBASE-T SFP+ transceiver module RJ-45 98 ft TAA compliant
10GBASE-T SFP+ transceiver with RJ-45 interface supporting up to 98 ft and TAA compliance
- 10 GbE SFP+ copper link reaches 98 ft over Cat6a
- TAA compliant module approved for federal procurement projects
- Hot-swappable SFP+ form factor fits Ubiquiti UF-RJ45-10G slots
- RJ-45 connector uses familiar twisted-pair cabling
- Lightweight 0.05 lb design adds minimal port load
Axiom AXG97440 10GBASE-T transceiver
This Axiom AXG97440 module delivers 10GBASE-T connectivity through an SFP+ slot using an RJ-45 interface. It supports links up to 98 ft and meets TAA compliance requirements for government and regulated projects. The unit weighs 0.05 lbs and is designed as a direct equivalent to the Ubiquiti UF-RJ45-10G transceiver. It suits network administrators adding copper 10 GbE ports to compatible switches or routers.
Fits SFP+ cages with RJ-45 cabling
Insert the transceiver into any SFP+ port that accepts 10GBASE-T modules, then connect standard Cat6a or better copper patch cords to the RJ-45 jack. The module frees you from running fibre patch cables for short runs up to 98 ft, simplifying rack or desk-side deployments. Ensure the host device lists 10GBASE-T SFP+ support in its hardware compatibility list before installation. No additional power adapters or software licences are required for basic operation.
Suits copper 10 GbE upgrades in TAA environments
This transceiver suits IT teams that need TAA-compliant 10 GbE copper links over existing Cat6a infrastructure within 98 ft. It is not for deployments requiring longer distances, fibre media, or multi-gigabit speeds beyond 10 GbE. Buyers whose switches lack 10GBASE-T SFP+ support should verify compatibility before purchase. Those needing higher port densities or different form factors will need alternative solutions.
Highlights
- 10 GbE SFP+ copper link reaches 98 ft over Cat6a
- TAA compliant module approved for federal procurement projects
- Hot-swappable SFP+ form factor fits Ubiquiti UF-RJ45-10G slots
- RJ-45 connector uses familiar twisted-pair cabling
- Lightweight 0.05 lb design adds minimal port load
Specifications
No published specifications for this item yet.
Questions about this item
How far can the 10GBASE-T link run over Cat6a cable?
The module supports up to 98 ft over standard RJ-45 copper cabling at 10 Gbps.
How much heat or noise does the transceiver add inside a switch?
It is a passive copper transceiver with no fan; power draw is low and it adds no audible noise.
Which switch port type must the buyer already have to use this module?
An SFP+ cage that accepts 10GBASE-T copper transceivers is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
