We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black SFP+ transceiver module with LC ports

Axiom

Axiom 721000-002-AX 10GBASE-SW iSCSI SFP+ transceiver

SKU CH-X0MC-9B104 MPN 721000-002-AX

10 GBps SFP+ transceiver operates at 850 nm wavelength for 300 m multimode links

  • 10 Gbps data rate for high-speed iSCSI storage links
  • 850 nm wavelength optimised for multimode fibre deployments
  • 300 m maximum reach covers typical data-centre rack distances
  • LC duplex interface ensures secure, low-loss connections
  • SFP+ form factor fits standard HP-compatible switch and server ports

Axiom 10GBASE-SW SFP+ Transceiver

The Axiom 721000-002-AX is a 10 GBps SFP+ transceiver built for 10GBASE-SW iSCSI links. It uses an 850 nm wavelength and LC interfaces to connect switches, servers or storage arrays over multimode fibre. The module is new and matches the HP 721000-002-AX part number for direct replacement.

Suits 10 Gb iSCSI over multimode fibre

This transceiver fits networks running 10 Gb iSCSI where the link distance stays within 300 m on OM3 or OM4 multimode cable. It is not a fit for buyers who require single-mode reach or who need higher line rates for newer storage fabrics. The SFP+ form factor limits use to ports that accept this specific module type.

300 m maximum transfer distance

The 300 m reach at 850 nm is the single specification that decides whether this part works in a given link. Longer runs or single-mode cabling will not operate with this module. Verify the fibre type and distance before purchase.

Highlights

  • 10 Gbps data rate for high-speed iSCSI storage links
  • 850 nm wavelength optimised for multimode fibre deployments
  • 300 m maximum reach covers typical data-centre rack distances
  • LC duplex interface ensures secure, low-loss connections
  • SFP+ form factor fits standard HP-compatible switch and server ports

Specifications

No published specifications for this item yet.

Questions about this item

Which switch or server port must I already have free to install this SFP+ transceiver?

You need an available SFP+ slot that supports 10 Gbps Ethernet or 10GBASE-SW iSCSI, typically found on 10 Gigabit switches, routers or server NICs.

Will this 850 nm module work on the same multimode fibre links as my older 10 Gbps optics?

Yes — if the existing link uses OM3 or OM4 multimode fibre with LC connectors and runs at 10 Gbps, the 850 nm wavelength and 300 m reach match those parameters.

How can I confirm the link is operating at the rated 10 Gbps after I insert the module?

Check the switch or NIC port statistics: the interface should report a 10 Gbps link speed, zero CRC errors and an RX power level within the normal range for 850 nm multimode.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.