Avantalk
Avantalk 8MP 4-in-1 Dome Camera 2.8mm 100° 65ft IR IP66
An 8 MP dome camera with 2.8 mm lens, 100° view, 65 ft IR night vision and IP66 metal housing for outdoor use
- 8MP resolution captures fine detail with 4-in-1 TVI/CVI/AHD/CVBS output
- 8mm fixed lens gives 100° wide view for broad area coverage
- 65ft IR night vision provides clear footage in low-light conditions
- IP66 metal housing withstands -40F to 140F for outdoor reliability
- DIP switch lets you match video mode to your 8MP DVR
8MP 4-in-1 Dome Camera
This Avantalk dome camera captures 8 megapixel video over TVI, CVI, AHD and 960H outputs. It requires a 4K 8MP DVR and will not function with 5MP or lower recorders. The fixed 2.8mm lens gives a 100 degree field of view. Infrared illumination reaches 65ft for night monitoring.
DVR Compatibility Upgrade
The camera replaces older analog or lower resolution cameras that cannot feed an 8MP recorder. The jump is worth it when the DVR already supports 4K 8MP recording and the installer needs multi-format output flexibility. A DIP switch on the body selects TVI, CVI, AHD or CVBS mode to match the DVR type. Default output is 4MP TVI.
Build Integration
The IP66 rated metal housing withstands outdoor conditions from -40F to 140F. The unit has no internal recording or remote view capability; it must connect to a compatible DVR for storage and management. Power and video cabling are required to complete the installation. The fixed lens eliminates focus adjustment during setup.
Highlights
- 8MP resolution captures fine detail with 4-in-1 TVI/CVI/AHD/CVBS output
- 8mm fixed lens gives 100° wide view for broad area coverage
- 65ft IR night vision provides clear footage in low-light conditions
- IP66 metal housing withstands -40F to 140F for outdoor reliability
- DIP switch lets you match video mode to your 8MP DVR
Specifications
No published specifications for this item yet.
Questions about this item
What size mounting holes does the 2.8 mm dome camera need for ceiling or wall installation?
The camera uses a standard dome base with three screw holes spaced for a 4-inch junction box; no proprietary bracket is required.
How do I change the video mode on the DIP switch to match my 8 MP DVR?
Remove the dome cover, locate the four-position DIP switch on the circuit board, and set it to the TVI, CVI, AHD or CVBS position that matches your DVR before powering up.
When should I clean the IR LEDs or replace the weather seals on this IP66 housing?
Wipe the IR window with a soft cloth whenever night vision looks hazy, and inspect the rubber gasket each year; replace it if cracks appear after extreme -40 °F to 140 °F cycles.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



