Avantalk
Avantalk 440 lbs Magnetic Mount Kit for Starlink Gen 3 2 in 1 accessory
Magnetic mount kit secures a Starlink Gen 3 dish to vehicle roofs with four 110-pound neodymium magnets for 440 pounds of vertical pull
- Secure hold with 440 lb total magnetic force
- Gentle on paint thanks to rubber-coated magnets
- Rust-free durability from 304 stainless steel hardware
- Designed for temporary roof mounting on vehicles
- Stable performance in strong wind conditions
Avantalk Starlink Gen 3 Magnetic Mount Kit
The Avantalk 440 lbs Magnetic Mount Kit is a 2-in-1 accessory designed to temporarily secure a Starlink Gen 3 dish to a vehicle roof. It uses four rubber-coated neodymium magnets to hold the bracket in place on iron surfaces. Each magnet delivers 110 pounds of pulling force for a combined vertical rating of 440 pounds. All hardware components are made from 304 stainless steel to resist rust during long-term outdoor exposure.
Suited for mobile and temporary installs on metal
This kit suits owners who need a quick, non-permanent way to mount a Starlink Gen 3 dish on a car, camper, SUV, trailer or RV roof. The rubber coating protects the vehicle paint from scratches. It is not intended for permanent fixed-site installations or for use during hurricane conditions. Buyers who need a bolted or welded mount for high-vibration off-road travel should look at a different mounting solution.
440 lb combined magnetic holding force on ferrous
The single specification that decides fit is the 440-pound total vertical pulling force generated by the four 110-pound neodymium magnets. This force only applies when the magnets contact a clean, flat ferrous metal surface such as a steel roof. Aluminium, fibreglass or carbon-fibre roofs will not work with this kit.
Highlights
- Secure hold with 440 lb total magnetic force
- Gentle on paint thanks to rubber-coated magnets
- Rust-free durability from 304 stainless steel hardware
- Designed for temporary roof mounting on vehicles
- Stable performance in strong wind conditions
Specifications
No published specifications for this item yet.
Questions about this item
Does the 440-pound magnetic pull create heat or noise when the kit stays on the roof all day?
The kit uses passive neodymium magnets with rubber coating and 304 stainless-steel hardware, so it generates no heat and makes no noise during continuous use.
What must my vehicle already have for the magnetic mount to work?
The four 110-pound magnets require a ferromagnetic roof surface such as steel; aluminium, fibreglass or carbon-fibre roofs will not hold the kit.
Will the rubber-coated magnets and stainless hardware damage the paint on an older car roof?
Each magnet is covered with a rubber layer specifically designed to prevent paint damage, and all hardware is 304 stainless steel that will not rust or stain the surface.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
