Avantalk
Avantalk 2 in 1 Accessory 12V 60cm 90° Lemo 0B to Locking DC Barrel
A 12V power cable connects Lemo 0B 2-pin sources to locking 5.5×2.5mm DC devices with a 60cm 90° rotatable plug
- 12V power for Atomos, SmallHD and Lectrosonics gear
- Works with Video Devices PIX-E and Decimator Design converters
- Draws power from ARRI Alexa, RED, Sony and Z CAM 2-pin sources
- Lemo 0B 2-pin male to locking 5.5×2.5 mm DC barrel
- 60 cm flexible cable with adjustable 90° right-angle connector
12V Lemo 0B Power Cable for Production Monitors
This 60 cm cable connects cameras or power sources that use a 2-pin Lemo 0B connector to monitors and receivers with a locking 5.5×2.5 mm DC barrel input. It carries 12 V and is built for professional video rigs including Atomos Shogun 7, Ninja Inferno, Shogun Flame and SmallHD 702 Touch displays.
Suited for single-camera operators who need
The 90° plug points upward with the red dot at 12 o’clock and the collet can be rotated with a spanner to suit the rig. Buyers who need a longer run, a straight connector or a different barrel size should look at something else.
Adjustable right-angle collet changes cable routing
Unscrewing the ring lets you rotate the cable exit to the desired position, reducing strain on the monitor port. The 60 cm length keeps the run tidy on a cage or gimbal without excess slack.
Highlights
- 12V power for Atomos, SmallHD and Lectrosonics gear
- Works with Video Devices PIX-E and Decimator Design converters
- Draws power from ARRI Alexa, RED, Sony and Z CAM 2-pin sources
- Lemo 0B 2-pin male to locking 5.5×2.5 mm DC barrel
- 60 cm flexible cable with adjustable 90° right-angle connector
Specifications
No published specifications for this item yet.
Questions about this item
Which power source must I already have to use this cable?
You need a device with a Lemo 0B 2-pin male output such as an ARRI Alexa, RED, Sony or Z CAM E2 series camera.
Will the 90-degree rotated connector clear my Atomos Shogun 7 monitor when mounted on a rig?
The right-angle plug points upward with the red dot at 12 o'clock and the collet can be rotated with a spanner to suit your rig layout.
How can I confirm the 12 V feed is reaching my Atomos Ninja Inferno after connecting the cable?
Power the source device and verify the monitor boots normally and shows its usual voltage readout on screen.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



