We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Clear blue polyurethane tubing coil 5/32 inch ID 1/4 inch OD 250 feet

Atp

Atp PU25-BCB Trap Clear Blue 5/32 in ID 1/4 in OD 250 ft

SKU CH-N7SM-FSK5C MPN PU25-BCB

Clear blue polyurethane tubing with 5/32 in inside diameter and 1/4 in outside diameter, supplied in a 250 ft coil

  • TypeDrain Components
  • ColorClear Blue
  • Clear Blue colour simplifies line identification
  • 5/32 in ID and 1/4 in OD suit compact air or water circuits
  • 250 ft coil reduces joins in long runs
  • Polyurethane construction rated to 180 psi and 140 Degrees F
  • Shore A 98 hardness gives abrasion and wear resistance

Clear Blue Polyurethane Tubing

ATP PU25-BCB tubing is a clear blue polyurethane line built for air and water circuits in automotive and general plumbing tasks. It ships as a 250 ft coil with a 5/32 in inside diameter and a 1/4 in outside diameter. The material carries a Shore A 98 hardness rating for abrasion and wear resistance.

Suited for low-pressure fluid transfer

This tubing fits workshops that need a flexible, chemical-resistant line for pneumatic tools, coolant loops or wash-down stations rated to 180 psi and 140 °F. It is not intended for peristaltic pump setups or hot-water systems that exceed the listed temperature ceiling. Buyers who require a jacketed hose, a different diameter pairing or a higher pressure rating should look at alternative products.

180 psi maximum operating pressure

The 180 psi ceiling at 140 °F is the single figure that determines whether this coil matches the system design. Verify the working pressure and temperature of the circuit before specifying this part.

Highlights

  • Clear Blue colour simplifies line identification
  • 5/32 in ID and 1/4 in OD suit compact air or water circuits
  • 250 ft coil reduces joins in long runs
  • Polyurethane construction rated to 180 psi and 140 Degrees F
  • Shore A 98 hardness gives abrasion and wear resistance

Specifications

TypeDrain Components
ColorClear Blue
BrandATP
ModelPU25-BCB

Questions about this item

What inside and outside diameters must my fittings match for the 5/32 in ID and 1/4 in OD tubing?

Fittings need a 5/32 in inside diameter and a 1/4 in outside diameter to seal correctly on this polyurethane tubing.

How do I cut and secure the 250 ft roll, and what step is often missed?

Cut square with a sharp tube cutter, slide the fitting on fully past the barb, then clamp; the step often missed is not pushing the tube far enough past the last barb.

When should I replace the tubing given its 180 psi rating and 140 °F limit?

Replace if the clear blue wall turns cloudy, shows surface cracks, or permanently deforms after exposure near the 180 psi or 140 °F limits.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.