ARTU USA INC
ARTU USA INC 01282 SDS Plus Drill Bit 5/8" x 12" pneumatic accessory
SDS Plus drill bit with 5/8 inch diameter and 12 inch overall length for 10 inch maximum drilling depth
- Drills up to 10 in deep in concrete
- 12 in overall length reaches through thick material
- SDS Plus shank locks securely in rotary hammers
- Chrome-vanadium steel resists wear on hard aggregate
- 5/8 in diameter suits anchor and rebar holes
Application & Fit
This SDS Plus drill bit suits professionals and DIY users who need a 5/8 inch diameter hole in concrete or masonry. The 12 inch overall length allows a maximum drilling depth of 10 inches. It fits SDS Plus rotary hammers with a 9/16 inch shank diameter. Buyers who need a different diameter or a longer reach should choose another accessory.
Sustained Use
The CrV construction resists wear when the bit is driven through abrasive material for extended periods. Heat builds steadily during continuous hammering, so the cutting edges stay sharp longer than softer steel alternatives. The flute design clears dust efficiently to maintain cutting speed. Operators who run the tool at full load for hours will see consistent progress without frequent bit changes.
Thermals & Power
Friction at the tip generates the primary heat, while the shank transmits vibration to the tool body. The steel body conducts warmth away from the cutting zone during normal cycles. Noise levels follow the rotary hammer’s own rating rather than adding a distinct tone. Power draw depends entirely on the connected hammer’s motor and the load applied by the user.
Highlights
- Drills up to 10 in deep in concrete
- 12 in overall length reaches through thick material
- SDS Plus shank locks securely in rotary hammers
- Chrome-vanadium steel resists wear on hard aggregate
- 5/8 in diameter suits anchor and rebar holes
Specifications
| Brand | ARTU |
|---|
Questions about this item
Does the 12 in SDS Plus bit generate noticeable vibration or heat during extended concrete drilling?
The CrV steel construction resists heat buildup and the SDS Plus shank transfers impact efficiently, keeping vibration low during long drilling sessions.
What rotary hammer do I need to accept the 9/16 in shank diameter?
Any SDS Plus rotary hammer with a standard SDS Plus chuck will accept the 9/16 in shank directly; no adapter is required.
Will the 10 in maximum drilling depth work with my older SDS Plus hammer that has a shorter chuck travel?
The 10 in drilling depth is independent of chuck travel; the bit reaches full depth as long as the hammer provides standard SDS Plus impact energy.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
