ARTU USA INC
ARTU USA INC 01243 SDS Plus Drill Bit 3/8" x 10"L pneumatic accessory
SDS Plus drill bit with 10 in overall length and 8 in maximum drilling depth
- SDS Plus shank fits rotary hammers directly
- 10 in overall length reaches deep holes
- 3/8 in bit drills precise 3/8 in diameter
- 8 in maximum drilling depth handles thick material
- CrV steel resists wear for longer life
Purpose and fit
This SDS Plus drill bit is built for rotary-hammer users who need a 3/8 inch cutting diameter and a 10 inch overall reach. It suits electricians, plumbers and masonry contractors drilling anchor or conduit holes in concrete, brick or block. The 8 inch maximum drilling depth covers most through-fixture and embedment tasks without requiring a longer bit. It is not for buyers who need a larger diameter or a different shank system.
Build and connection
The bit uses an SDS Plus shank with a 5/16 inch shank diameter for positive drive in compatible rotary hammers. Chrome-vanadium steel construction provides hardness and wear resistance for repeated impacts. The fluted body clears dust efficiently during deep drilling. It is not for users whose tools accept only SDS Max, spline or straight-shank accessories.
Heat, noise and power
CrV steel dissipates heat generated by hammer action, reducing tip degradation during sustained drilling. Standard rotary-hammer vibration and noise levels apply; no additional damping features are described. The bit draws power only from the host tool, adding no electrical load of its own. It is not for operators who require integrated dust-extraction channels or active cooling features.
Highlights
- SDS Plus shank fits rotary hammers directly
- 10 in overall length reaches deep holes
- 3/8 in bit drills precise 3/8 in diameter
- 8 in maximum drilling depth handles thick material
- CrV steel resists wear for longer life
Specifications
| Brand | ARTU |
|---|
Questions about this item
What shank standard does the 01243 bit use and what diameter does it fit?
The bit uses an SDS Plus shank with a 5/16 in diameter that locks into SDS Plus rotary hammers.
What overall length and flute clearance does the 10 in bit need in the chuck and workpiece?
The bit measures 10 in overall with an 8 in maximum drilling depth, so the chuck must accept the full shank and the hole must allow 8 in of flute travel.
How is the 01243 bit installed in an SDS Plus hammer and what step is often missed?
Insert the shank until it clicks into the SDS Plus chuck, then pull back firmly to confirm the locking balls have engaged — skipping that pull-back check is the common error.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
