ARENTI
ARENTI POA-LMP136 330W Projector Lamp 4000-6000h
330W replacement projector lamp lasting 4000-6000 hours for Sanyo and Christie models
- 330W lamp powers bright projection for large venues
- 4000-6000 hour rated life reduces replacement frequency
- Compatible with Sanyo PLC-WM5500, PLC-XM150, PLC-ZM5000 series
- Fits Christie LW555, LWU505, LX605 projectors
- Tool-free installation completed in minutes without technician
Direct Replacement Lamp
The ARENTI POA-LMP136 is a 330W projector lamp rated for 4000-6000 hours of average life. It fits Sanyo PLC-WM5500, PLC-WM5500L, PLC-XM150, PLC-XM150L, PLC-ZM5000, PLC-ZM5000L and PLC-ZM5000S models as well as Christie LW555, LWU505 and LX605 units. The lamp ships new and ready for immediate installation.
Upgrade From Dim Or Failed Lamps
When an original lamp drops below usable brightness or reaches its rated hour limit, this unit restores the projector’s output without a technician visit. The swap takes only a few minutes and suits owners who want a brighter, cleaner light source than low-cost imitations deliver. Buyers needing a different wattage or a non-listed model should look elsewhere.
Fits Existing Projector Housing
The lamp slots into the compatible Sanyo and Christie housings using the original mounting points and power connector. No extra cables, adapters or firmware updates are required, freeing up bench time and avoiding downtime. Installers should verify the exact model number on the projector before ordering.
Highlights
- 330W lamp powers bright projection for large venues
- 4000-6000 hour rated life reduces replacement frequency
- Compatible with Sanyo PLC-WM5500, PLC-XM150, PLC-ZM5000 series
- Fits Christie LW555, LWU505, LX605 projectors
- Tool-free installation completed in minutes without technician
Specifications
No published specifications for this item yet.
Questions about this item
What projector models does the POA-LMP136 lamp fit?
It fits Sanyo PLC-WM5500, PLC-WM5500L, PLC-XM150, PLC-XM150L, PLC-ZM5000, PLC-ZM5000L, PLC-ZM5000S and Christie LW555, LWU505, LX605 projectors.
How is the lamp installed and what step is often missed?
The lamp module slides into the projector compartment and locks with a screw; the step often missed is resetting the lamp-hour counter in the projector menu after fitting the new module.
When will the POA-LMP136 lamp need replacement?
The lamp is rated for 4000 to 6000 hours of typical use; plan to replace it once the projector warns that the lamp life has been reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



