We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black armored fiber patch cable with ST connectors and pulling eye kit

ARENTI

ARENTI 2 in 1 accessory 1300ft 400m ST-ST single mode armored TPU pulling eye

SKU CH-7916-Y86AZ

ST-to-ST single-mode duplex patch cable, 400 m outdoor armoured TPU jacket with pulling eye kit, -40 °C to +85 °C operation

  • Operates from -40°C to +85°C for extreme environments
  • TPU jacket resists abrasion, water, oil and UV exposure
  • Dual stainless-steel armor stops rodent and crush damage
  • 600 N tensile and 3000 N compression strength for heavy pulls
  • Pre-terminated pulling eye protects connectors during 400 m installation

Single-mode ST patch cable

This 400 metre single-mode patch cable uses ST connectors on both ends and is built for outdoor and direct-burial runs. A stainless-steel spiral armor tube and a TPU jacket protect the 9/125 µm glass core from rodents, crushing and weather.

Installers needing pull-friendly armored fiber

The pre-terminated pulling eye on one end lets crews pull the cable through conduit without stressing the connectors. Buyers who need a different connector type or a shorter indoor patch cord should look elsewhere.

Sustained outdoor installation load

Rated for 600 N tensile and 3000 N compressive strength, the cable holds its geometry during long pulls and after burial. The G.657.A2 bend-insensitive fiber tolerates a 7.5 mm minimum bend radius across a -40 °C to +85 °C operating range.

Highlights

  • Operates from -40°C to +85°C for extreme environments
  • TPU jacket resists abrasion, water, oil and UV exposure
  • Dual stainless-steel armor stops rodent and crush damage
  • 600 N tensile and 3000 N compression strength for heavy pulls
  • Pre-terminated pulling eye protects connectors during 400 m installation

Specifications

No published specifications for this item yet.

Questions about this item

What connectors does my patch panel or switch need to accept this ST‑ST duplex cable?

The cable uses ST connectors on both ends, so your patch panel or switch must provide ST duplex ports for each fiber strand.

Can I route this armored cable alongside older G.652.D single‑mode fibers in the same tray?

Yes, the G.657.A2 fiber inside is fully compatible with G.652.D fibers, so they can share the same pathway without splice loss issues.

How do I confirm the link is performing correctly after installation?

Measure insertion loss and return loss with a single‑mode light source and power meter; the cable’s bend‑insensitive fiber and armor should yield stable readings across the full length.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.