ARCTIC
ARCTIC P8 PWM PST 5 Pack 80 mm Case Fan
Five 80 mm case fans with PWM sharing technology for synchronous speed control from 200 to 3000 RPM
- Synchronous speed control across fans via PWM Sharing Technology
- Pressure-optimised design delivers 23.4 CFM airflow at 3000 RPM
- Efficient motor runs quietly at 0.3 Sone noise level
- Wide 200 to 3000 RPM range for flexible cooling
- Five 80 mm fans included for multi-point case airflow
80 mm PWM Case Fan Five-Pack
This pack contains five ARCTIC P8 PWM PST fans built for 80 mm mounting points. Each unit uses a 4-pin PWM connector and shares speed signals through PWM Sharing Technology so all connected fans run in sync. The pressure-optimised blade design targets heatsinks and radiators where airflow meets resistance. A neodymium magnet ring motor keeps vibration low across the speed range.
Builders Who Need Synchronised 80 mm Cooling
The five-pack suits builders populating multiple 80 mm slots in compact cases or on dense radiators and want single-cable speed control. Buyers who need fewer than five fans or who require larger frame sizes should look at other configurations. Systems without 4-pin PWM headers cannot use the synchronous control feature. The pressure focus makes these less ideal for unrestricted intake or exhaust paths.
200 to 3000 RPM Speed Range
Fan speed spans 200 to 3000 RPM regulated by the 4-pin PWM signal. At the top speed the fan moves 23.4 CFM or 40.3 m³/h while producing 0.3 Sone. This range and the pressure-oriented curve decide whether the fan matches the thermal load and noise target of your build.
Highlights
- Synchronous speed control across fans via PWM Sharing Technology
- Pressure-optimised design delivers 23.4 CFM airflow at 3000 RPM
- Efficient motor runs quietly at 0.3 Sone noise level
- Wide 200 to 3000 RPM range for flexible cooling
- Five 80 mm fans included for multi-point case airflow
Specifications
No published specifications for this item yet.
Questions about this item
What motherboard header is required to run the ARCTIC P8 PWM PST fans?
A 4-pin PWM header is needed for each fan or for the first fan in a PST chain, because the pack uses 4-pin connectors and PWM Sharing Technology for synchronous speed control.
Can the ARCTIC P8 PWM PST fans share a PWM signal with older 3-pin fans on the same header?
No, the PWM Sharing Technology only synchronises other 4-pin PWM fans; 3-pin voltage-controlled fans will not follow the shared PWM curve and should stay on separate headers.
How do I confirm the ARCTIC P8 PWM PST fans are spinning at the correct 200 to 3000 RPM range after installation?
Check the fan-speed readout in BIOS or monitoring software; it should report speeds between 200 RPM at minimum and 3000 RPM at full PWM duty cycle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Kensington Desk Mount Cable Anchor K64613WW accessory
- Black
- Provides a secure a…
Panasonic CF-VDR291U laptop cooling pad
- Optical Drive
- Buffer Size: 2 MB B…
eReplacements PB992A-ER laptop battery 14.4V
- Battery
- Lithium-Ion



