ARCTIC
ARCTIC MagBench Clip-on Mouse Pad 2 in 1 accessory
Clip-on mouse pad attaches to MagBench workstation rails and also holds a phone or cup
- Clip-on mouse pad attaches securely to MagBench workstations via three-groove magnetic ribs
- Ambidextrous mounting works on left or right side of Utility or Standard models
- Side rails keep mouse from sliding off even at full incline angle
- Multi-purpose surface also holds a phone or coffee cup within easy reach
- Simple press-on installation requires no tools or adhesives
Clip-on Mouse Pad for MagBench
The ARCTIC MagBench Clip-on Mouse Pad is a dedicated accessory for the MagBench Utility and Standard workstations. It attaches to either side of the bench using three grooves that lock onto molded ribs. The pad provides a stable tracking surface for mouse use while the workstation is flat or tilted.
Side Rails for Secure Use
Integrated side rails run along the edges of the pad to prevent a mouse from sliding off during use. This protection remains effective even when the MagBench Standard is set to its full incline position. The flat surface can also support a phone or a coffee cup alongside the mouse.
Passive Surface with No Power Draw
The accessory operates without any power connection, active cooling or moving parts. It adds no noise, heat or electrical load to the workstation setup. Thermals and acoustics are determined entirely by the host MagBench unit and the devices placed upon it.
Highlights
- Clip-on mouse pad attaches securely to MagBench workstations via three-groove magnetic ribs
- Ambidextrous mounting works on left or right side of Utility or Standard models
- Side rails keep mouse from sliding off even at full incline angle
- Multi-purpose surface also holds a phone or coffee cup within easy reach
- Simple press-on installation requires no tools or adhesives
Specifications
No published specifications for this item yet.
Questions about this item
Does the MagBench Clip-on Mouse Pad work with both the Utility and Standard MagBench models?
Yes, it attaches to either the Utility or Standard MagBench by pressing the three grooves onto the molded ribs on either side.
What keeps the mouse from sliding off when the MagBench Standard is tilted to its full incline?
Built-in side rails on the pad prevent the mouse from falling off even at the maximum incline angle of the MagBench Standard.
How do you install the MagBench Clip-on Mouse Pad onto the workstation?
Align the three grooves on the underside of the pad with the molded ribs on the left or right side of the MagBench and press firmly until seated.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
