Appliance Factory Parts
Appliance Factory Parts 62600215 White Thermistor Kit
Genuine Friedrich thermistor kit replaces part 62600215 across 51 Friedrich and one Frigiking room-air-conditioner models
- Selling UnitEach
- TypeAppliances
- Genuine Friedrich thermistor kit ensures exact temperature control
- Compatible with 51 Friedrich models for broad replacement coverage
- Also fits Frigiking KCQ08A10A unit for cross-brand use
- White colour matches original appliance aesthetics
- Part number 62600215 simplifies ordering and identification
Genuine Friedrich thermistor kit
This Appliance Factory Parts 62600215 thermistor kit is a genuine Friedrich component designed for temperature sensing in compatible air-conditioning units. It serves as a direct replacement for the original white thermistor in Friedrich and Frigiking models. The kit restores accurate temperature control when the factory sensor fails or drifts out of specification. Installers and service technicians use it to return the appliance to factory performance.
Thermals noise and power draw
The thermistor is a passive sensor that draws no measurable power and produces no audible noise during operation. Its resistance changes with temperature, allowing the unit's control board to regulate cooling cycles without adding thermal load. Because it contains no moving parts or active electronics, it does not affect the system's overall power consumption or acoustic profile. Normal use imposes no additional thermal or electrical burden on the appliance.
Compatibility with fifty-one Friedrich models
This kit fits fifty-one listed Friedrich model numbers including KCS08A10A, KCS10A10A, KCS12A30A, KES12A33A, KCL24A30A and KCL36A30A among others. It also fits the single Frigiking model KCQ08A10A. Buyers whose unit is not on the published compatibility list cannot use this part and must source the correct sensor for their specific model. Verifying the exact model number before purchase avoids ordering a sensor that will not connect or calibrate.
Highlights
- Genuine Friedrich thermistor kit ensures exact temperature control
- Compatible with 51 Friedrich models for broad replacement coverage
- Also fits Frigiking KCQ08A10A unit for cross-brand use
- White colour matches original appliance aesthetics
- Part number 62600215 simplifies ordering and identification
Specifications
| Brand | Appliance Factory Parts |
|---|---|
| Selling Unit | Each |
| Part Number | 62600215 |
| Type | Appliances |
Questions about this item
How do I install the 62600215 thermistor kit in a Friedrich KCS08A10A and what step is often missed?
Disconnect power, remove the front panel, locate the evaporator coil sensor clip, swap the old thermistor for the white kit probe, reseat the clip firmly, then reassemble; the step most often missed is re-engaging the retaining clip so the sensor stays in contact with the coil.
What maintenance or replacement will the 62600215 thermistor kit need over time?
The thermistor itself is a solid-state sensor with no moving parts, so it requires no scheduled maintenance; replacement is only needed if resistance readings drift out of spec or the harness insulation becomes brittle from long-term heat exposure.
What limit appears first when the 62600215 thermistor kit runs continuously in a Friedrich unit?
The first limit is the sensor's own thermal time constant — under sustained compressor cycles the probe can lag actual coil temperature by several seconds, causing the control board to short-cycle the compressor until the reading stabilises.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
YINGHUA
YINGHUA 30A 2-channel relay module optocoupler 5V high low trigger
$10.99
0.00013104BTC
In stock