Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00937381BTC
In stock
Apollo
Apollo 77VLF14301 Manual 2-Way Ball Valve Press Brass
Manual two-way brass ball valve for water with full-port stainless steel ball, 300 psi operating pressure and 29 in Hg vacuum rating
- TypeOther
- Full-port stainless-steel ball ensures unrestricted water flow
- Brass body rated to 300 psi handles high-pressure lines
- Lever handle gives quick manual on/off control
- Vacuum service rated to 29 in Hg for reliable sealing
- California Proposition 65 warning notes chemical hazards
Apollo 77VLF14301 Brass Ball Valve
This manual two-way ball valve uses a brass body with a stainless steel ball. The full-port design handles water service at up to 300 psi operating pressure. It carries a vacuum service rating of 29 in Hg and a 15 psi steam rating. The lever handle is non-locking.
Who This Suits And Who It Does Not
Installers needing a press-connect valve for residential or light commercial water lines will find the 1/2 in nominal size convenient. The valve is not rated for combustible gas service. Buyers requiring 3-A sanitary compliance or a locking handle should look at other models.
Installation Notes And Common Issues
Press connections require the correct tool and jaw set for the tubing used. Improper pressing is the most frequent cause of leaks. Verify that local codes accept this valve for the intended application. The Proposition 65 warning indicates chemical content that may affect material selection in some jurisdictions.
Highlights
- Full-port stainless-steel ball ensures unrestricted water flow
- Brass body rated to 300 psi handles high-pressure lines
- Lever handle gives quick manual on/off control
- Vacuum service rated to 29 in Hg for reliable sealing
- California Proposition 65 warning notes chemical hazards
Specifications
| Brand | APOLLO |
|---|---|
| Type | Other |
Questions about this item
Which pipe size and press tool must I already have to install the 1/2 in press-end valve?
You need 1/2 in copper or stainless tubing and a compatible press tool with the correct jaw for that diameter.
Will the 300 psi rated brass body and stainless ball handle the same pressures as my existing 1/2 in threaded valves?
Yes, the valve is rated for 300 psi water working pressure and 15 psi steam, matching typical residential supply conditions.
How can I verify the full-port ball is sealing correctly after pressing the connections?
Pressurise the line and inspect each press joint for leaks; the lever should move freely from fully open to fully closed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
