Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00940502BTC
In stock
Apollo
Apollo 77VLF10401 Manual 2-Way Ball Valve Press Brass
Manual two-way ball valve in brass for water service rated to 300 psi with a full-port design and lever handle
- TypeOther
- Manual two-way ball valve controls water flow
- Brass body resists corrosion in plumbing systems
- Full-port design maintains unrestricted water passage
- Rated for 300 psi maximum operating pressure
- Lever handle provides simple quarter-turn operation
Brass Ball Valve for Water Lines
This Apollo 77VLF10401 is a manual two-way ball valve built from brass for water service. Its full-port design maintains flow without restriction through a straight two-piece body. The lever handle operates without a locking mechanism. It suits residential and light-commercial plumbing where a reliable shut-off is required.
Replaces Threaded or Soldered Shut-Offs
The press connection eliminates the need for pipe thread sealant or solder, cutting installation time on copper tubing. The step is worth it when a project demands a flame-free joint and a 300 psi operating pressure rating. It is not for steam lines above 15 psi or for combustible gas service, which this valve does not rate.
Press-Fit Installation on Copper
The valve installs with a standard press tool on compatible copper tube, creating a permanent mechanical joint. Common issues include pressing on debris-contaminated tubing or using the wrong jaw size, both of which can prevent a seal. The 29 in Hg vacuum rating confirms a tight joint when the press is executed correctly.
Highlights
- Manual two-way ball valve controls water flow
- Brass body resists corrosion in plumbing systems
- Full-port design maintains unrestricted water passage
- Rated for 300 psi maximum operating pressure
- Lever handle provides simple quarter-turn operation
Specifications
| Brand | APOLLO |
|---|---|
| Type | Other |
Questions about this item
What pipe size does the 3/4 in nominal valve require for press connections?
The valve is designed for a 3/4 in nominal pipe size; use compatible press fittings and the correct jaw profile for that diameter to ensure a leak-free joint.
How do I install the press ball valve without damaging the brass body?
Clean the tube ends, mark the insertion depth, press with a calibrated tool using the proper jaw for 3/4 in tubing, and avoid over-pressing which can deform the two-piece brass body.
When should I replace the valve given its pressure and vacuum ratings?
Replace the valve if it can no longer hold 300 psi water pressure, 15 psi steam pressure, or 29 in Hg vacuum, or if the lever handle becomes stiff or the brass ball shows wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
