We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Bronze gate valve with rising stem and wheel handle

Apollo

Apollo 30LF00701PR Gate Valve 1-1/2 in 200 psi

SKU CH-EMGG-PW4WM MPN 30LF00701PR

A 1-1/2 inch bronze gate valve rated for 200 psi water and steam service with a rising stem and press connection

  • TypeDrain Components
  • Low-lead bronze body reduces lead exposure
  • Rising stem design shows valve position at a glance
  • 200 psi rating handles high-pressure water and steam
  • 119 Cv coefficient allows strong flow capacity
  • EPDM seal resists wear in hot water systems

Apollo 1-1/2 in Gate Valve

This Apollo gate valve is built for potable-water systems that require low-lead bronze construction. It fits 1-1/2 inch press connections and handles operating pressures up to 200 psi. The rising-stem design with a bronze wheel handle gives clear visual indication of valve position. Installers working on commercial or residential supply lines will find the solid-wedge bronze seat reliable for on-off service.

Upgrade from threaded bronze valves

Press-end connections remove the need for pipe threading and reduce joint count on copper tubing. The EPDM seals and screw-in bonnet simplify maintenance without special tools. The jump is worth it when a project specifies press-fit copper and lead-free compliance under California Proposition 65 requirements. It does not suit installations that require flanged ends or non-rising stems.

Sustained pressure performance

The bronze body and wedge maintain a Cv of 119 at the rated 200 psi working pressure, including steam duty at the same rating. Rising-stem operation stays consistent through repeated cycles because the stem and bonnet share the same bronze alloy. Seal integrity holds under continuous load without the degradation seen in short-burst tests. Not intended for throttling or modulating flow.

Highlights

  • Low-lead bronze body reduces lead exposure
  • Rising stem design shows valve position at a glance
  • 200 psi rating handles high-pressure water and steam
  • 119 Cv coefficient allows strong flow capacity
  • EPDM seal resists wear in hot water systems

Specifications

TypeDrain Components
BrandApollo
Model30LF00701PR

Questions about this item

What pipe size does the 1-1/2 in press connection on this valve fit?

The press connection is sized for 1-1/2 in nominal pipe, so it fits standard copper or steel tubing of that diameter.

Which step is most often missed when pressing this valve onto the pipe?

Installers sometimes forget to fully seat the tubing against the internal stop before pressing, which can leave a leak path.

When should the EPDM seal be inspected or replaced on this gate valve?

Check the EPDM seal during routine system maintenance or if you notice seepage around the bonnet or stem packing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.