We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Anvil malleable iron cross fitting with four female NPT ports

Anvil

Anvil 0310070206 Malleable Iron Cross Class 150 trap

SKU CH-540D-N7G3V MPN 0310070206

Malleable iron cross fitting with four 1-inch female NPT ports rated Class 150 for Schedule 40 pipe at 300 psi maximum operating pressure

  • TypeDrain Components
  • MaterialHAWA
  • Malleable iron construction resists corrosion and mechanical stress
  • Class 150 rating suits standard Schedule 40 piping systems
  • Four 1-inch female NPT ports enable flexible cross-connection layouts
  • Rated for 300 psi at 150 °F maximum operating pressure
  • Anvil 0310070206 model ensures consistent manufacturing quality

Malleable Iron Cross Fitting

The Anvil 0310070206 is a Class 150 cross designed for Schedule 40 pipe systems. It provides four female NPT connections, each sized at 1 inch, for branching drainage or fluid lines in commercial and residential installations. The fitting is manufactured from malleable iron for structural rigidity under pressure. It arrives in new condition, ready for assembly.

Build Quality And Threaded Connections

Malleable iron construction resists cracking under mechanical stress and thermal cycling better than standard cast iron. The four female NPT ports accept standard tapered pipe threads, allowing direct connection without additional adapters. Class 150 rating supports a maximum operating pressure of 300 psi at 150 degrees Fahrenheit. Thread engagement follows Schedule 40 dimensions for reliable sealing with pipe dope or tape.

Replaces Lower-Rated Or Damaged Crosses

This cross upgrades from fittings rated below Class 150 or from corroded units that leak at the threads. The jump is worth it when system pressure approaches 300 psi or when thermal loads reach 150 degrees Fahrenheit. It is not suited for piping schedules thinner than Schedule 40 or for applications requiring welded rather than threaded joints. Buyers needing more than four outlets or a different port configuration must select another fitting type.

Highlights

  • Malleable iron construction resists corrosion and mechanical stress
  • Class 150 rating suits standard Schedule 40 piping systems
  • Four 1-inch female NPT ports enable flexible cross-connection layouts
  • Rated for 300 psi at 150 °F maximum operating pressure
  • Anvil 0310070206 model ensures consistent manufacturing quality

Specifications

TypeDrain Components
MaterialHAWA
BrandAnvil
Model0310070206

Questions about this item

What pipe schedule does the Class 150 malleable iron cross accept?

It is rated for Schedule 40 pipe, matching the Class 150 pressure class of the fitting.

What thread size and type do the four outlets use?

Each outlet is a 1 inch female NPT thread for direct connection to standard pipe.

How do you seal the joints without cracking the iron?

Apply PTFE tape or pipe dope to male threads, hand-tighten, then turn one to two full turns with a wrench; over-tightening splits the casting.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.