Anvil
Anvil 0310001607 1-1/2" Malleable Iron 90 Degree Elbow trap
Malleable iron 90-degree elbow with female NPT threads rated 300 psi at 150 degrees F
- TypeDrain Components
- Malleable iron construction resists corrosion and impact
- 90-degree elbow redirects flow in tight spaces
- Class 150 rating handles 300 psi at 150 °F
- Female NPT threads seal without extra adapters
- Fits Schedule 40 pipe for standard installations
Anvil 1-1/2" Malleable Iron 90° Elbow
This Anvil 0310001607 is a 90-degree elbow fitting made from malleable iron with a black finish. It is rated Class 150 for use with Schedule 40 pipe and carries a maximum operating pressure of 300 psi at 150 degrees Fahrenheit. The fitting provides a directional change in piping systems for plumbing professionals and maintenance crews.
Verify pipe schedule and thread compatibility
Confirm that your existing piping uses Schedule 40 dimensions and 1-1/2 inch female NPT threads on both connection points. The fitting is designed for this specific schedule and thread type, so mismatched pipe or thread standards will prevent a proper seal. Check the system pressure and temperature limits against the 300 psi at 150 degrees Fahrenheit rating before installation.
Suits Schedule 40 systems needing a 90° turn
This elbow suits installers joining two lengths of 1-1/2 inch Schedule 40 pipe with female NPT threads where a right-angle change of direction is required. It is not for systems using different pipe schedules, thread types, or larger diameters. Buyers needing a straight coupling, a different angle, or a material other than malleable iron should look at other fittings.
Highlights
- Malleable iron construction resists corrosion and impact
- 90-degree elbow redirects flow in tight spaces
- Class 150 rating handles 300 psi at 150 °F
- Female NPT threads seal without extra adapters
- Fits Schedule 40 pipe for standard installations
Specifications
| Type | Drain Components |
|---|---|
| Brand | Anvil |
| Model | 0310001607 |
Questions about this item
Does the Anvil 0310001607 elbow come with any gaskets or sealant, or must I buy thread tape separately?
The fitting is supplied as a single malleable iron elbow; thread sealant or tape for the NPT connections is not included and must be purchased separately.
How do I decide between the Class 150 and other pressure classes for this 1-1/2" NPT elbow?
Class 150 is the only class offered for this model; it is rated for 300 psi at 150 °F and matches Schedule 40 pipe, so no alternative class selection is needed.
What does the 300 psi @ 150 °F rating mean when the elbow is installed in a hot water line?
It indicates the maximum continuous pressure the joint can withstand at that temperature; above 150 °F the allowable pressure drops, so the system must stay within both limits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
