Anest Iwata
Anest Iwata 4926 HVLP sprayer 1/4 in
HVLP spray gun with 1.1 mm nozzle, 0.7 cfm air consumption at 10 psi, 5 fl oz gravity cup and 1/4 in air inlet
- ColorTransparent
- Low air use at .7 cfm @ 10 psi
- Precise 1.1 mm nozzle for fine finish
- Gravity cup holds 5 fl oz for longer runs
- 1/4 in air inlet fits standard hoses
- Model 4926 built by Anest Iwata
HVLP spray gun for gravity-feed finishing
The Anest Iwata 4926 is a gravity-fed HVLP spray gun designed for low-to-medium fluid delivery. Its 1.1 mm nozzle produces a fan pattern from 1/4 in to 6 in, making it suited for detail work and smaller panels. A 5 fl oz cup holds enough material for touch-ups without frequent refills. The 1/4 in air inlet connects to standard shop couplers.
Air consumption and low-pressure operation
The gun draws 0.7 cfm at 10 psi, keeping compressor demand modest and overspray low. HVLP atomisation at this pressure reduces bounce-back and material waste on typical clear coats, base coats and single-stage finishes. Low fluid delivery speed gives the operator time to control film build on vertical surfaces. Noise and vibration remain at typical air-tool levels for this class.
Integration with shop air and cup system
A 1/4 in air inlet fits common regulator and hose fittings without adapters. The gravity cup mounts directly on the body, eliminating a separate pressure pot and hose run. Builders who need higher volume or larger pattern widths will need a different gun. The transparent cup lets you monitor fluid level at a glance.
Highlights
- Low air use at .7 cfm @ 10 psi
- Precise 1.1 mm nozzle for fine finish
- Gravity cup holds 5 fl oz for longer runs
- 1/4 in air inlet fits standard hoses
- Model 4926 built by Anest Iwata
Specifications
| Brand | ANEST IWATA |
|---|---|
| Color | Transparent |
Questions about this item
How do I connect the 1/4 in air inlet and set the pressure correctly?
Attach a 1/4 in air hose to the inlet and regulate the supply to 10 psi; the gun consumes .7 cfm at that setting, so verify the compressor can sustain it before spraying.
Which parts will need cleaning or replacement after repeated use?
The 1.1 mm nozzle, fluid needle and 5 fl oz gravity cup should be cleaned after every job; the needle packing and air-cap seals typically wear first and are the usual replacement items.
What limits the spray pattern width during a long session?
The fan adjusts from 1/4 in to 6 in, but sustained low-to-medium fluid delivery can cause the cup to run dry before the pattern narrows, so refill the 5 fl oz cup promptly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
