Amphenol
Amphenol Connex 202109-10 RF Coaxial Terminator N Plug 50 Ohm
50 Ohm N-type male RF coaxial terminator prevents signal reflection in 50 Ohm systems
- TypeSpecialty Equipment Lamps
- Straight body style enables direct port termination
- N-type plug interface mates with standard RF connectors
- 50 Ohm impedance matches common coaxial systems
- Terminator function absorbs signal reflections reliably
- New condition ensures factory-spec performance out of box
RF Coaxial Terminator N Plug 50 Ohm
The Amphenol Connex 202109-10 is a straight-body terminator that plugs directly into an N-type jack. It provides a 50 ohm load for unused RF ports in test, broadcast or communications equipment. The part is supplied new and carries manufacturer code 99H6097.
Passive Component No Active Thermals
As a passive terminator the device generates no heat of its own and adds no audible noise to the installation. Power draw is limited to the RF energy it absorbs, which is determined by the signal source rather than the terminator itself. No cooling or external supply is required.
Terminates Open N Ports Without Extra Hardware
The plug-style body mates straight to an N jack so no adapter pigtail or bracket is needed. The 50 ohm impedance matches standard coaxial systems and prevents reflections on unused ports. SVHC status is to be advised by the manufacturer.
Highlights
- Straight body style enables direct port termination
- N-type plug interface mates with standard RF connectors
- 50 Ohm impedance matches common coaxial systems
- Terminator function absorbs signal reflections reliably
- New condition ensures factory-spec performance out of box
Specifications
| Type | Specialty Equipment Lamps |
|---|
Questions about this item
How do I install this N-plug terminator on an open N jack?
Screw the straight N plug onto the mating N jack by hand until the coupling nut seats firmly; the common error is leaving a gap that raises VSWR.
What maintenance or replacement will the 50 ohm terminator need later?
Inspect the contact pin and dielectric for corrosion or cracking after prolonged RF exposure; replace the unit if return loss degrades.
What limit appears first when the terminator handles continuous RF power?
The 50 ohm resistive element will overheat before any connector wear occurs, so sustained power must stay within the device's rated dissipation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
GE Lighting
GE Lighting 28885 T8 Linear Fluorescent Light Bulb 24 inch 17W 5000K Coverguard 6 pack
$29.99
0.00035338BTC
In stock
GE
GE 61362 Fluorescent T5 46 inch 54W 5000K G5 base accessory
- Fluorescent Tube
$140.99
0.00166132BTC
In stock