Amer Mounts HYDRA2GB Dual Monitor Mount Hydralift Pneumatic Arms monitor accessory

Dual monitor mount for 17–32 inch screens

The HYDRA2GB holds two displays weighing up to 19.8 lbs each using gas-pneumatic Hydralift arms that move smoothly through a wide range of motion. A built-in 180 degree rotation stop prevents the arms from striking walls or partitions. Top-side installation means the unit fastens entirely from above the desk surface, and a detachable VESA plate simplifies screen attachment. Integrated cable routing keeps wires tidy along the slender arm profile.

19.8 lb capacity per arm with 180° stop

Each arm comfortably supports monitors from 17 to 32 inches up to the 19.8 lb limit, giving ample headroom for most modern panels. The rotation stop caps swing at 180 degrees, so the mount runs out of travel before it can contact adjacent surfaces. Heavier displays beyond the stated weight or screens larger than 32 inches exceed the design envelope and are not supported. The gas-pneumatic mechanism maintains consistent resistance across the full adjustment range.

Clamp or grommet base with top-side access

The package includes both a desk clamp and a grommet mount, allowing installation on surfaces where drilling is not possible or where a through-hole already exists. Because all hardware tightens from above, there is no need to reach underneath the desk during setup or later repositioning. The 38.2 by 4.5 by 22.2 inch footprint and 13.42 lb weight require a sturdy worksurface. Builders needing triple-monitor arrays or monitors heavier than 19.8 lbs per arm should look elsewhere.