Amcrest
Amcrest AMCPFB203W-B Wall Mount Bracket for Dome Cameras
Aluminium wall bracket hides wiring for compatible Amcrest dome cameras
- Conceals wiring for a cleaner install with built-in cable management
- Aluminium construction resists corrosion for long-term outdoor use
- Supports eleven Amcrest dome models including 751, 851, 856, 956, 1028, 1056, 1176 and 2493 series
- Complete mounting kit supplied with ST4 screws, plastic anchors, M4 screws and Allen wrench
- Black finish blends discreetly with most exterior surfaces
Amcrest AMCPFB203W-B Wall Mount Bracket
This aluminium bracket secures compatible Amcrest dome cameras to a wall surface. The black finish matches the camera housing for a discreet appearance. It is intended for indoor or outdoor installations where a dome unit needs wall mounting.
Installers hiding cables and connectors
The hollow body conceals wiring and connectors for a clean finish. It suits technicians fitting the listed Amcrest dome models. Buyers with non-Amcrest domes or cameras requiring a ceiling or pole mount should look at other brackets.
Simple four-screw wall installation
The package includes four ST4 screws, four plastic anchors, three M4 screws and an Allen wrench. Drill pilot holes, insert anchors, fasten the bracket, then attach the camera with the M4 screws. Misaligned anchor holes are the most common issue; use a level and measure twice before drilling.
Highlights
- Conceals wiring for a cleaner install with built-in cable management
- Aluminium construction resists corrosion for long-term outdoor use
- Supports eleven Amcrest dome models including 751, 851, 856, 956, 1028, 1056, 1176 and 2493 series
- Complete mounting kit supplied with ST4 screws, plastic anchors, M4 screws and Allen wrench
- Black finish blends discreetly with most exterior surfaces
Specifications
No published specifications for this item yet.
Questions about this item
Which Amcrest dome camera models does the AMCPFB203W-B bracket support?
The bracket is compatible with IPM-751B/W, IP2M-851B/W, IP2M-851EB/W, IP3M-956B/W, IP3M-956EB/W, IP2M-856EW, IP4M-1028B/W, IP4M-1028EB/W, IP4M-1056E, IP5M-1176E and IP8M-2493E dome cameras.
Can I reuse the existing mounting hardware from an older Amcrest dome camera when switching to this bracket?
The package supplies its own ST4 screws, plastic anchors, M4 screws and an Allen wrench, so you can install the bracket without relying on older hardware.
How can I verify the bracket is correctly installed and the camera is secure?
After mounting, check that all supplied screws are fully tightened with the Allen wrench, the camera sits flush against the bracket and cables are concealed inside the housing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
