ALSEYE
ALSEYE 2 in 1 Accessory 13.3" FHD 1920x1080 30 Pin
A 13.3 inch FHD IPS replacement panel with a 30 pin bottom right connector, tested for compatibility
- 3 inch FHD panel gives crisp visuals at 1920x1080
- 30 pin bottom right connector ensures direct fit
- IPS technology provides wide viewing angles
- ISO compliant with under 3 to 5 dead pixels
- Tested compatible replacement for Lenovo FRU 02DA373
Replacement Screen for Lenovo 2-in-1
This 13.3 inch IPS panel replaces a damaged display in compatible Lenovo 2-in-1 laptops. It delivers a 1920x1080 FHD resolution through a 30-pin connector located on the bottom right side. The screen is a non-touch LCD module supplied without mounting brackets. Condition is new and meets ISO standards allowing up to five dead pixels.
Suitable for DIY Repair of Specific Models
Technicians and owners repairing a Lenovo unit matching part numbers SD10M34138 or FRU 02DA373 can use this panel. It is not for buyers needing a touchscreen digitiser or a complete assembly with hinges and bezel. Builders working on other brands or different screen sizes should look elsewhere. Compatibility is verified by the supplier but outline dimensions may vary slightly between batches.
30-Pin Bottom-Right Connector Decides Fit
The single specification that determines whether this part works is the 30-pin connector positioned on the bottom right edge. Your original screen must use the identical pin count and connector location to mate with the laptop cable. Resolution and diagonal size must also match 1920x1080 and 13.3 inches respectively.
Highlights
- 3 inch FHD panel gives crisp visuals at 1920x1080
- 30 pin bottom right connector ensures direct fit
- IPS technology provides wide viewing angles
- ISO compliant with under 3 to 5 dead pixels
- Tested compatible replacement for Lenovo FRU 02DA373
Specifications
No published specifications for this item yet.
Questions about this item
Will this 13.3 inch screen fit my Lenovo laptop using part number SD10M34138?
Yes, the screen matches Lenovo part SD10M34138 and FRU 02DA373; it is a 13.3 inch panel with a 30 pin connector on the bottom right side.
How do I install the screen and what step is often missed?
Disconnect power and battery, remove the bezel, swap the panel, then reconnect the 30 pin cable firmly at the bottom right; the step often missed is reseating that cable fully before reassembly.
What maintenance or replacement should I expect for this LCD later?
The panel is ISO compliant with under 3 to 5 dead pixels; no user maintenance is required, but if backlight dims or pixel faults exceed the spec the whole screen would need replacement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



