We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Carbon fiber camera monopod, six telescopic sections, rubber grip, extends to 61 inches

Alphacool

Alphacool 2 in 1 accessory 61 inch 6 section carbon fiber monopod 16 lbs

SKU CH-JZCX-7BXSD

A 61-inch, six-section carbon fibre monopod supports cameras up to 16 lbs

  • 61 inch maximum height for flexible shooting angles
  • 6-section telescopic design retracts to compact size for travel
  • 28 mm carbon fiber tubes balance lightweight portability and rigidity
  • 3K and twill weave construction resists shock and corrosion
  • 16 lb load capacity supports DSLR, mirrorless and telephoto lenses

Carbon-fibre monopod for camera support

This Alphacool 2 in 1 accessory is a 61 inch carbon-fibre monopod built for DSLR, mirrorless and camcorder users who need a single adjustable pole. The six-section telescopic design locks at multiple heights and collapses for travel, while the 28 mm tube diameter and 16 lbs load rating suit a wide range of lenses and shooting scenarios.

Carbon-fibre construction handles vibration

The 3K and twill-weave carbon-fibre tubes damp vibration better than aluminium and resist corrosion during outdoor use, keeping the monopod light without sacrificing rigidity. A thickened non-slip rubber grip replaces sponge handles, reducing hand fatigue and maintaining control in damp or sweaty conditions.

Extended height remains stable under sustained load

At the full 61 inch extension the six locking sections hold a 16 lbs payload without creeping, so long exposures or video pans stay steady. The carbon-fibre material does not conduct heat or cold to the hand, and the rubber grip stays secure during prolonged sessions such as wildlife waits or event coverage.

Highlights

  • 61 inch maximum height for flexible shooting angles
  • 6-section telescopic design retracts to compact size for travel
  • 28 mm carbon fiber tubes balance lightweight portability and rigidity
  • 3K and twill weave construction resists shock and corrosion
  • 16 lb load capacity supports DSLR, mirrorless and telephoto lenses

Specifications

No published specifications for this item yet.

Questions about this item

How do I extend the 6-section carbon-fiber legs to the full 61 inches without the locks slipping?

Unlock each of the six twist locks in sequence, pull the sections out until the white alignment marks line up, then re-tighten every lock firmly; the most common mistake is leaving the lowest lock loose, which lets the monopod collapse under a 16 lb load.

Which part will wear out first and need replacement after heavy outdoor use?

The rubber foot at the base takes the brunt of ground contact and grit; it is the only consumable component and should be swapped when the tread flattens or the rubber cracks.

At what load does the 28 mm top tube start to flex noticeably during long video takes?

The monopod is rated for a maximum of 16 lbs; staying at or below that limit keeps the 28 mm carbon-fiber tube rigid enough for steady panning, while heavier rigs introduce visible bowing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.