We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular 3.6V 14500mAh battery pack with flat black finish and wire leads

Alexor WT4911B 14500mAh 3.6V battery charger

SKU CH-VX9Z-8WAFG MPN AlexorWT4911B

Replacement 14500mAh 3.6V PLC battery fits Alexor WT4911B flow analyser models

  • High-capacity 14500mAh 3.6V power for extended runtime
  • Compact 60.20 x 35.10 x 33.40mm design fits tight spaces
  • ISO9001, RoHS and CE certified for safety assurance
  • Direct replacement for Alexor WT4911B and WT4911BATT models

Replacement PLC Battery for Alexor Analyzers

This 3.6V 14500mAh lithium battery replaces the original power cell in Alexor WT4911B and WT4911BATT flow analysers. It is built to the same 60.20 x 35.10 x 33.40mm form factor so it fits the existing compartment without modification. The unit carries ISO9001, RoHS and CE certification for regulated environments.

Low Self-Discharge Chemistry for Standby Reliability

The cell uses a low self-discharge chemistry that holds charge during long storage periods between analyser sessions. It delivers steady 3.6V output with minimal voltage sag under the intermittent loads typical of portable flow analysis. No active cooling is required and the sealed construction eliminates electrolyte leakage risk.

Highlights

  • High-capacity 14500mAh 3.6V power for extended runtime
  • Compact 60.20 x 35.10 x 33.40mm design fits tight spaces
  • ISO9001, RoHS and CE certified for safety assurance
  • Direct replacement for Alexor WT4911B and WT4911BATT models

Specifications

BrandCameron Sino
ModelAlexor WT4911B WT4911BATT Cameron Nuflo MC-II Plus EXP MC-III Plus EXP Flow Analyzer MC-II Plus

Questions about this item

How do I install the Alexor WT4911B battery into my flow analyzer, and what step is commonly missed?

Power off the analyzer, open the battery compartment, align the 60.20 x 35.10 x 33.40mm pack with the 3.6V terminals, and secure the latch; the step often missed is verifying the latch clicks fully to prevent vibration disconnects.

What maintenance or replacement will the 14500mAh PLC battery need over time?

Expect capacity fade after several hundred charge cycles; plan to replace the 3.6V pack when run-time drops below your workflow needs, and store at partial charge if the analyzer sits unused for weeks.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.