AKG ACOUSTICS
AKG ACOUSTICS K702 Open-Back Reference Studio Headset
Open-back reference headphones for precision mixing with a flat-wire voice coil, 62-ohm impedance, 105 dB sensitivity and detachable 3 m cable
- Wireless TypeWired
- Open design delivers spacious, airy sound for critical listening
- Varimotion two-layer diaphragm extends highs to 39800 Hz and improves low-frequency response
- Flat-wire voice coil raises sensitivity to 105 dB SPL/V for detailed transient reproduction
- 62-ohm impedance and 200 mW power handling suit professional studio gear
- Detachable 3 m cable with mini XLR and replaceable 3D-foam ear pads ensure long-term comfort and serviceability
Reference Open-Back Studio Headphones
The AKG K702 is a wired, over-ear headphone built for precision listening, mixing and mastering. Its open-back architecture creates a spacious, airy soundstage without the pressure build-up of closed designs. Individually checked and serial-numbered units ensure consistent reference performance for professional audio work.
62 Ohm Impedance and Detachable Cable
At 62 ohms and 105 dB SPL/V sensitivity, the K702 demands a capable headphone amplifier or audio interface to reach its full dynamic range. A 3 metre detachable cable terminates in a mini XLR connector on the headphone side, allowing quick replacement or alternative cable runs without soldering.
For Critical Listening and Studio Production
Engineers and producers who need neutral, detailed reproduction for mixing and mastering will benefit from the flat-wire voice coil and Varimotion diaphragm. Casual listeners or commuters seeking noise isolation, wireless convenience or enhanced bass should look at closed-back or portable models instead.
Highlights
- Open design delivers spacious, airy sound for critical listening
- Varimotion two-layer diaphragm extends highs to 39800 Hz and improves low-frequency response
- Flat-wire voice coil raises sensitivity to 105 dB SPL/V for detailed transient reproduction
- 62-ohm impedance and 200 mW power handling suit professional studio gear
- Detachable 3 m cable with mini XLR and replaceable 3D-foam ear pads ensure long-term comfort and serviceability
Specifications
| Wireless Type | Wired |
|---|
Questions about this item
How does the 105 dB SPL/V sensitivity translate when driven by a typical audio interface?
At 105 dB SPL per volt the K702 reaches loud monitoring levels with modest voltage, so most studio interfaces or headphone amplifiers can drive them cleanly without needing excessive gain.
What does the 62-ohm impedance mean for amplifier matching?
The 62-ohm load is easy for virtually any professional headphone output; it draws enough current for good damping yet does not demand a high-voltage amp, so portable and desktop sources both work well.
How does the detachable mini-XLR cable attach and what length is supplied?
A 3 m cable terminates in a mini-XLR plug that locks into the left earcup, allowing quick replacement or upgrade without soldering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Mickey Technology Soundbar Speaker 12.95in Black Blue LED
- Soundbar
- 12.95 x 3.7 x 3.66…



