Advanced Lamps
Advanced Lamps MODEL-85-LAMP-A DLP Replacement Lamp
Replacement lamp and housing compatible with Runco Model 85 projectors, weighing .9900 and backed by a 90 day warranty
- TypeProject Lamp
- Weight0.9900
- Genuine AL Series lamp module for Runco MODEL 85 projector
- Complete lamp and housing unit simplifies installation
- 90 day warranty backs the replacement lamp
- New aftermarket component weighs .9900
- Compatible with Vidikron MODEL 85 projectors
Advanced Lamps MODEL-85-LAMP-A Projector Lamp
The Advanced Lamps MODEL-85-LAMP-A is a new projector lamp and housing assembly built for the Runco MODEL-85 projector. It uses a Genuine AL Series lamp module and arrives fully assembled inside its housing for direct installation. The unit weighs 0.9900 and carries a 90 day warranty from the supplier.
Compatible with Runco MODEL-85 and Vidikron MODEL 85
This lamp fits the Runco MODEL-85 and Vidikron MODEL 85 projectors where a complete lamp-and-housing module is required. It is not for owners of other projector models or for buyers who need a bare bulb without the housing. It also does not suit users looking for an original equipment manufacturer bulb instead of the AL Series lamp.
Genuine AL Series lamp type
The lamp type is Genuine AL Series, which defines the light source technology inside this housing. Buyers should verify that their projector service documentation specifies this lamp type before ordering. The 90 day warranty period covers the module against early failure.
Highlights
- Genuine AL Series lamp module for Runco MODEL 85 projector
- Complete lamp and housing unit simplifies installation
- 90 day warranty backs the replacement lamp
- New aftermarket component weighs .9900
- Compatible with Vidikron MODEL 85 projectors
Specifications
| Brand | Advanced Lamps |
|---|---|
| Model | MODEL-85-LAMP-A |
| Part Number | MODEL-85-LAMP-A |
| Type | Project Lamp |
| Weight | 0.9900 |
Questions about this item
How do I install the lamp and housing into my Runco MODEL-85 projector?
Power off and unplug the projector, let it cool completely, remove the lamp cover, unscrew the old module, insert the new MODEL-85-LAMP-A housing until it seats firmly, replace screws and cover, then reset the lamp timer in the menu.
What maintenance or replacement will this lamp need after the 90 day warranty period?
The AL Series lamp will gradually lose brightness; plan to replace the module again once the image dims noticeably or the projector signals end of life, typically after several thousand hours of use.
What limit appears first during long viewing sessions with this MODEL-85-LAMP-A?
Heat buildup in the projector chassis is the first constraint; if ventilation is restricted the lamp may trigger thermal shutdown before its rated hours are reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



