Advanced Lamps
Advanced Lamps E20.9n 330W-370W 0.8 AC Bare Projector Lamp 69555-CB
A 330W-370W 0.8 AC bare projector lamp replacing part 69555 for DLP devices
- TypeProject Lamp
- Weight0.5000
- Bright 330–370 W output powers clear projection
- 8 lens ratio suits short-throw installations
- Replaces part 69555 for direct compatibility
- Lightweight 0.5000 kg design eases handling
- 90-day warranty backs reliable performance
What This Lamp Replaces
This Advanced Lamps bare projector lamp is rated at 330W to 370W with a 0.8 current spec and carries the E20.9n designation. It directly replaces the original 69555 part used in compatible DLP projectors and rear-projection TVs. The unit ships new and weighs 0.5000.
Who Should Buy And Who Should Not
Buyers needing a direct 69555 replacement with the stated wattage range and current rating will find this lamp matches the original specification. Installers who require a pre-assembled module with housing or cage should look elsewhere because this is a bare lamp only. Users whose projectors call for a different wattage or connector type cannot use this part.
The Deciding Specification
The critical figure is the 330W-370W power range combined with the 0.8 AC current rating under the E20.9n designation. If the service manual for your projector lists those exact electrical parameters and the 69555 part number, this bare lamp is the correct match; if either value differs, the lamp will not operate correctly.
Highlights
- Bright 330–370 W output powers clear projection
- 8 lens ratio suits short-throw installations
- Replaces part 69555 for direct compatibility
- Lightweight 0.5000 kg design eases handling
- 90-day warranty backs reliable performance
Specifications
| Brand | Advanced Lamps |
|---|---|
| Model | 69555-CB |
| Part Number | 69555-CB |
| Type | Project Lamp |
| Weight | 0.5000 |
Questions about this item
What projector models does the E20.9n 330W-370W 0.8 AC Bare Lamp replace?
The Advanced Lamps E20.9n bare lamp replaces part number 69555 used in compatible DLP projectors and rear-projection TVs.
What physical space and weight allowance does the bare lamp need inside the projector?
The bare lamp weighs 0.5000 and fits the existing E20.9n housing without additional mounting hardware.
How is the bare lamp installed and what step is often missed?
Insert the bare E20.9n lamp into the original housing, secure the connector, and reset the projector's lamp-hour counter after installation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



