Adafruit
Adafruit 7" 1080P Dual Camera Monitor Kit TZ102 2 in 1 accessory
A 7-inch 1080P monitor kit with dual IP69 waterproof cameras, 18 infrared LEDs for 50-foot night vision, and 9–36 volt power for trucks and trailers
- Sharp 7" 1080P display improves rear visibility with 1920*1080 resolution
- DIY plug-and-play setup powers from 9-36 volts using car charger or hardwire
- IP69 waterproof cameras survive heavy weather and wash-downs
- Infrared night vision with 18 LEDs reveals objects up to 50 feet behind
- IR remote controls mirror flip, brightness, contrast and colour settings
7-inch Dual-Camera Kit for Commercial Vehicles
This kit pairs a 7-inch 1080P monitor with two cameras for trucks, trailers, RVs and pickup trucks. It delivers a 1920 by 1080 pixel image for reversing, security monitoring and general manoeuvring. The system is designed for drivers who need a wide, clear view behind large vehicles.
IP69 Waterproof Build with 9-to-36-Volt Power
Both cameras carry an IP69 rating, protecting them against high-pressure water and dust in all weather conditions. The monitor and cameras operate from a 9 to 36 volt supply, allowing a simple car-charger connection or a hardwired installation. Night vision uses 18 infrared LEDs to illuminate objects up to 50 feet behind the vehicle in low light.
Stable Image Quality During Extended Use
The advanced 4-pin connector maintains the full 1080P resolution without signal drop-out during long journeys. An included IR remote lets the driver rotate the mirror image and adjust brightness, contrast and colour while driving. The plug-and-play design keeps the picture consistent whether the system is standing on the dash or mounted permanently.
Highlights
- Sharp 7" 1080P display improves rear visibility with 1920*1080 resolution
- DIY plug-and-play setup powers from 9-36 volts using car charger or hardwire
- IP69 waterproof cameras survive heavy weather and wash-downs
- Infrared night vision with 18 LEDs reveals objects up to 50 feet behind
- IR remote controls mirror flip, brightness, contrast and colour settings
Specifications
No published specifications for this item yet.
Questions about this item
How do I connect the dual cameras to the 7" 1080P monitor using the 4-pin connector?
Plug each camera cable into the monitor's 4-pin ports; the keyed connectors only fit one way, so pushing them in upside down is the common mistake.
What maintenance will the IP69 waterproof cameras and 18 LED infrared night vision need over time?
Rinse salt or mud off the lens covers periodically and check that the 4-pin plugs stay tight; the IP69 seals are not user-serviceable.
At what voltage does the 9-36 volt power input shut down first during a long haul with the monitor and both cameras running?
The system stops when supply drops below 9 volts, so a sagging battery or undersized wiring will cut the image before anything overheats.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
