We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue polyethylene tubing coil, ten feet length

Acorn

Acorn 2155-010-199 Blue PE Tubing 10 Ft

SKU CH-1VJP-DPWZK MPN 2155-010-199

Blue PE tubing, 1/8 in. O.D., supplies water to lavatory and shower pushbuttons over 10 ft

  • TypeDrain Components
  • Blue PE tubing suits lavatory and shower pushbuttons
  • 10 ft length provides ample material for installations
  • 1/8 inch O.D. fits standard drain component connections
  • Durable polyethylene construction resists corrosion in plumbing systems
  • Ready for immediate use in combination lavatory and toilet setups

Blue PE tubing for push-button fixtures

This 10-foot length of 1/8-inch outside-diameter polyethylene tubing is coloured blue for easy identification. It connects lavatory, shower and combination lavatory-and-toilet push-button actuators to their control valves. The material resists corrosion and scale build-up in potable-water systems. Supplied in a single coil ready for cutting to exact lengths on site.

Suitable for new installations

Installers fitting or servicing push-button lavatory and shower controls will find the size and material match the original equipment specification. The tubing is not intended for high-pressure mains distribution, hot-water recirculation loops or gas service. Buyers who need larger diameters, different colours or coil lengths other than ten feet should look at alternative products.

1/8-inch outside diameter by 10-foot length

The critical dimension is the 1/8-inch outside diameter, which must match the push-button fitting ports exactly. A mismatch will prevent a leak-free connection and cause the actuator to malfunction. Verify the port size on the existing hardware before ordering. The ten-foot coil provides enough length for typical single-fixture runs with minimal waste.

Highlights

  • Blue PE tubing suits lavatory and shower pushbuttons
  • 10 ft length provides ample material for installations
  • 1/8 inch O.D. fits standard drain component connections
  • Durable polyethylene construction resists corrosion in plumbing systems
  • Ready for immediate use in combination lavatory and toilet setups

Specifications

TypeDrain Components
BrandAcorn
Model2155-010-199

Questions about this item

What outer diameter push-button fittings does the 1/8 in. O.D. tubing connect to?

The blue PE tubing is sized at 1/8 in. outside diameter and is intended for lavatory, shower and combination push-button assemblies that accept that same 1/8 in. O.D. connection.

How do you cut and seat the 10 ft. coil without kinking the polyethylene?

Use a sharp tubing cutter for a clean square cut, then push the tube fully into the push-button fitting until it bottoms out; the common mistake is leaving a gap that lets the tube blow off under pressure.

When should the blue PE tubing be replaced in a push-button drain system?

Inspect annually for stress-whitening, surface cracking or permanent set at the fitting; replace the tubing if any of those signs appear or after several years of continuous hot-cold cycling.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.