Acer America
Acer EY.JDP05.002 projector lamp 180W P-VIP
Replacement projector lamp module with 180W P-VIP bulb and housing rated for 4000 to 5000 hours
- TypeProjector Lamp
- Wattage180W
- Lamp Life4,000 (Normal) - 5,000 (Economy) Hrs.
- Ready-to-install module saves setup time
- 180W P-VIP bulb matches original brightness
- 4000 hours normal use extends replacement interval
- 5000 hours economy mode lowers running cost
- Built to ISO 9001 quality standards
Genuine 180W P-VIP replacement module
This new Acer EY.JDP05.002 lamp module delivers a complete bulb-and-housing assembly rated at 180W for direct installation in compatible Acer projectors. It is intended for owners who need a drop-in replacement without separate bulb handling.
Pre-assembled housing for tool-free swap
The unit arrives fully assembled, so the installer simply removes the old module and seats the new one without touching the bare lamp. Manufacturing follows ISO 9001 quality checks covering beam performance, ignition, voltage, connections and run-time.
Restores brightness after 4,000 to 5,000 hours
Rated life reaches 4,000 hours in normal mode and 5,000 hours in economy mode, matching the original specification. Buyers whose projectors have exceeded those hours will regain full output; those needing higher wattage or a different form factor should look elsewhere.
Highlights
- Ready-to-install module saves setup time
- 180W P-VIP bulb matches original brightness
- 4000 hours normal use extends replacement interval
- 5000 hours economy mode lowers running cost
- Built to ISO 9001 quality standards
Specifications
| Brand | Acer |
|---|---|
| Type | Projector Lamp |
| Wattage | 180W |
| Lamp Life | 4,000 (Normal) - 5,000 (Economy) Hrs. |
Questions about this item
Does the EY.JDP05.002 lamp use a standard socket or a proprietary connector?
The module ships as a complete housing with the P-VIP 180W bulb pre-installed, so it plugs directly into the projector's existing lamp connector without any wiring or adapter.
What clearance does the EY.JDP05.002 housing need inside the projector?
It is built to the original Acer EC.JCQ00.001 form factor, so it fits the same compartment and screw points as the factory lamp with no modification.
What is the correct reset procedure after installing the EY.JDP05.002 lamp?
After fitting the module, power on the projector and use the menu to reset the lamp-hour counter to zero; skipping this step leaves the old timer active and can trigger a premature replacement warning.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



