ABLEGRID
ABLEGRID White 147ft BNC Extension Cable
A 147 ft pre-made BNC video and power cable in white for security camera connections
- Battery TypeUPS
- 147 ft reach lets cameras install far from the recorder
- White jacket blends with light-coloured walls and ceilings
- Pre-made BNC video and power cord removes the need for separate wiring
- 100 % new cable arrives ready to terminate without splicing
- Compatible with Q-See QM6006B 600TVL bullet cameras for direct replacement
Ready-made BNC video and power extension
This 147 ft white cable carries both video and DC power for analogue security cameras. The all-in-one construction saves the installer from running separate coaxial and power leads. It is aimed at DIY or professional CCTV installs where a single pre-made run is preferred.
Suits fixed bullet cameras
The cable matches the Q-See QM6006B 600TVL bullet camera and similar devices that use a BNC video plug and a barrel power jack. It is not for IP cameras that need Ethernet cabling, nor for installations that require a longer run than the supplied length.
147 ft pre-made all-in-one BNC video and power cable
The single specification that decides fit is the 147 ft combined video and power length. Measure the exact route from recorder to camera before ordering, because the cable cannot be shortened or extended without re-terminating both ends.
Highlights
- 147 ft reach lets cameras install far from the recorder
- White jacket blends with light-coloured walls and ceilings
- Pre-made BNC video and power cord removes the need for separate wiring
- 100 % new cable arrives ready to terminate without splicing
- Compatible with Q-See QM6006B 600TVL bullet cameras for direct replacement
Specifications
| Brand | ABLEGRID |
|---|---|
| Battery Type | UPS |
Questions about this item
How long is the cable so I know if it reaches my camera?
The cable measures 147 ft, giving a long run between the DVR and a Q-See QM6006B 600TVL bullet camera.
Does the single pre-made cord carry both video and power to the camera?
Yes, the all-in-one BNC wire combines video signal and DC power in one jacket, so only one cable is pulled during installation.
When should I check the connectors for corrosion or wear?
Inspect the BNC and power plugs after the first 30 days and then at least once a year, especially on outdoor runs exposed to weather.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



