ABLEGRID
ABLEGRID AC-DC Adaptor Charger 48V 1.25A for Netgear GS110TP-200EUS GS110TP
A 48V 1.25A AC-DC power adapter with worldwide 100-240V input, over-voltage and over-heat protection, and a barrel tip for Netgear GS110TP switches
- Battery TypeUPS
- Delivers 48V 1.25A DC power to compatible Netgear switches
- Worldwide AC 100-240V input works on 50-60Hz mains
- Over-voltage and over-heat protection safeguards connected equipment
- CE FCC RoHS certified for regulatory compliance
- Includes power cable for immediate installation
Replacement Power Adapter for Netgear Switches
This ABLEGRID AC-DC adaptor supplies 48 V at 1.25 A to compatible Netgear ProSAFE GS110TP models. It accepts worldwide AC input from 100 V to 240 V at 50 Hz or 60 Hz and connects via a barrel tip. The unit includes a power cable and carries CE, FCC and RoHS certifications.
Upgrading from a Lost or Faulty Original Supply
The adapter replaces the factory PSU when the original is missing, damaged or no longer delivers stable voltage. Over-voltage and over-heat protection guard the switch during continuous operation. The jump is worth it when downtime from a dead power brick costs more than a direct replacement.
Limits of the Fixed 48 V Barrel Interface
Output voltage and current are fixed, so the adaptor cannot serve devices that require a different DC level or a higher amperage. Polarity and tip diameter must match the switch exactly; the supplier notes that buyers should verify both before ordering. Long-term use demands adequate ventilation and a dry environment.
Highlights
- Delivers 48V 1.25A DC power to compatible Netgear switches
- Worldwide AC 100-240V input works on 50-60Hz mains
- Over-voltage and over-heat protection safeguards connected equipment
- CE FCC RoHS certified for regulatory compliance
- Includes power cable for immediate installation
Specifications
| Brand | ABLEGRID |
|---|---|
| Battery Type | UPS |
Questions about this item
What barrel-tip size does the 48 V 1.25 A charger use for the Netgear GS110TP?
The adapter uses a barrel tip; verify the exact inner and outer diameter matches the GS110TP before ordering.
How do I install the power cable and adapter without damaging the connector?
Plug the IEC power cable into the adapter, then insert the barrel tip straight into the switch — forcing it at an angle bends the centre pin.
When should I replace the adapter if it runs continuously in a rack?
Replace it if the case becomes unusually hot, the output voltage drifts below 48 V, or the over-heat protection trips repeatedly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



