We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
ABLEGRID 9.6V 200mA charger with 2.5mm barrel plug, black plastic case

ABLEGRID

ABLEGRID 9.6V 200mA 2.5mm Barrel Plug Charger

SKU CH-5FF3-QK4G9

Replacement 9.6V 200mA adapter with 2.5mm barrel plug for select DOD pedals, worldwide 100-240V input

  • Battery TypeUPS
  • Worldwide AC input from 100 to 240 V
  • Delivers 9.6 V DC at 200 mA for compatible pedals
  • 5 mm barrel tip matches required connector
  • Over-voltage and over-heat protection built in
  • CE, FCC and RoHS certified for safety

AC adapter for legacy DOD pedals

This 9.6 V 200 mA barrel-plug supply replaces the original wall-wart for compatible DOD effects units. It accepts 100-240 V AC at 50-60 Hz so it works on mains power worldwide without a voltage selector. The 2.5 mm centre-positive tip matches the pedal's DC input exactly. Non-OEM construction is CE, FCC and RoHS certified for safety compliance.

Thermal behaviour and power draw

The adapter delivers a steady 9.6 V DC at up to 200 mA, a low current that keeps internal dissipation minimal during normal pedal operation. Over-voltage and over-heat protection circuits shut the unit down if a fault occurs, preventing damage to the connected effect. No active cooling is used, so the brick remains silent on a pedalboard. Warmth stays low even after hours of continuous play.

Tip polarity and voltage match

The single specification that decides fit is the 2.5 mm barrel connector with 9.6 V centre-positive output; pedals requiring a different voltage, current, tip diameter or polarity will not work with this unit. Verify the pedal's original adapter label before ordering to avoid mismatch. No other cable or adapter is included in the package.

Highlights

  • Worldwide AC input from 100 to 240 V
  • Delivers 9.6 V DC at 200 mA for compatible pedals
  • 5 mm barrel tip matches required connector
  • Over-voltage and over-heat protection built in
  • CE, FCC and RoHS certified for safety

Specifications

BrandABLEGRID
Battery TypeUPS

Questions about this item

How do I install the ABLEGRID 9.6V charger and what step do people often get wrong?

Plug the 2.5mm barrel tip into the pedal's power jack, then connect the AC plug to a 100-240V outlet. The step people miss is verifying the pedal requires exactly 9.6V DC at 200mA with centre-positive polarity before powering on.

What maintenance or replacement will the ABLEGRID 9.6V charger need later?

No routine maintenance is required. Keep the unit ventilated and away from humid or soft surfaces during long sessions. Replace the adapter if the cable frays, the barrel tip becomes loose, or the over-voltage and over-heat protections activate repeatedly.

What limit appears first on the ABLEGRID 9.6V charger under sustained use?

The 200mA current ceiling is the first limit. Drawing more than 200mA will trigger the over-current protection or cause voltage sag, so the charger is only suitable for pedals rated at or below 200mA at 9.6V DC.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.