A&K
A&K TLP-L6 Projector Lamp 150W 2000 Hrs
A 150 W UHP projector lamp rated for 2,000 hours, supplied as a complete housing for quick replacement
- TypeUHP
- Wattage150W
- Lamp Life2,000 Hrs.
- Ready-to-install lamp module saves setup time
- Genuine 150W UHP bulb delivers specified brightness
- Tested to ISO 9001 quality standards for reliable operation
- 2,000-hour rated life reduces replacement frequency
- Pre-assembled housing fits Toshiba TLP-L6 projectors
Ready-to-install lamp module
This projector lamp module arrives as a fully assembled 150W UHP bulb inside its housing so it fits straight into a Toshiba TLP-L6 projector without extra assembly. It is intended for owners of that model who need a direct replacement when the original lamp reaches end of life.
150W UHP bulb with 2000-hour rating
The single specification that determines compatibility is the 150W UHP bulb rated for 2000 hours of operation, matching the power and life figures specified for the TLP-L6. Buyers whose projector requires a different wattage or lamp life cannot use this module.
Consistent output over the rated lifespan
Manufactured to ISO 9001 standards, each unit is tested for beam performance, ignition, voltage, appearance, connections and run-time so brightness and colour remain stable throughout the 2000-hour rating rather than fading after a short burst. Projectors used continuously for longer daily sessions will still need a replacement once the rated hours are reached.
Highlights
- Ready-to-install lamp module saves setup time
- Genuine 150W UHP bulb delivers specified brightness
- Tested to ISO 9001 quality standards for reliable operation
- 2,000-hour rated life reduces replacement frequency
- Pre-assembled housing fits Toshiba TLP-L6 projectors
Specifications
| Brand | TOSHIBA |
|---|---|
| Type | UHP |
| Wattage | 150W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How many hours of projection will the 150 W UHP bulb actually deliver in a Toshiba projector?
The lamp is rated for 2,000 hours of operation at its 150 W power level, giving a typical service life before brightness drops to half.
What connection standard does the TLP-L6 module use to fit the projector?
The module is built as a direct plug-in replacement for the original Toshiba TLP-L6 housing, matching the factory connector and alignment pins exactly.
Does the assembled housing need any extra brackets or tools to mount inside the projector?
No extra brackets are required; the complete bulb-and-housing unit slides into the lamp compartment and secures with the projector's existing screws.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



