We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A&K Ask Proxima 970 projector lamp module with housing

A&K

A&K Ask Proxima 970 Projector Lamp 250W 2000 Hrs

SKU CH-NVCY-FSX3Z

New 250W projector lamp module with Philips UHP bulb and housing, rated 2,000 hours for Ask Proxima 970

  • TypeProjector Lamp
  • Wattage250W
  • Lamp Life2,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 250W UHP lamp delivers bright projection
  • 2000-hour rated life reduces replacement frequency
  • Manufactured to ISO 9001 quality standards
  • Compatible with A&K Ask Proxima 970 projectors

Ready-to-Install 250W Lamp Module

This A&K Ask Proxima 970 replacement lamp arrives as a fully assembled 250W bulb and housing unit. It is designed for immediate installation in compatible A&K projectors without additional assembly. The module uses a Philips UHP bulb and is built to ISO 9001 quality standards for reliable ignition and beam performance.

Direct OEM Replacement for Worn Lamps

The unit replaces an exhausted original lamp in the Ask Proxima 970 projector, restoring brightness and colour accuracy lost through ageing. Three OEM-sourced versions and one compatible version are available depending on stock, each verified for voltage, connections and run-time. The swap is worthwhile when the existing lamp reaches its rated lifespan or shows dimming and flicker.

Steady Output Across 2000-Hour Rating

The 250W UHP bulb maintains consistent luminance and stable voltage throughout its 2000-hour rated life under continuous operation. Quality checks confirm ignition reliability and beam uniformity during extended run-time rather than brief test cycles. The housing and connections are engineered to sustain thermal load without degradation over the full service interval.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 250W UHP lamp delivers bright projection
  • 2000-hour rated life reduces replacement frequency
  • Manufactured to ISO 9001 quality standards
  • Compatible with A&K Ask Proxima 970 projectors

Specifications

BrandA&K
TypeProjector Lamp
Wattage250W
Lamp Life2,000 Hrs.

Questions about this item

Will the SP-LAMP-006 housing fit the Proxima 970 projector without modification?

The lamp module ships as a fully assembled 250W bulb inside its housing, built to match the Proxima 970 form factor so it seats directly in the projector lamp bay.

What is the correct sequence to install the lamp module and avoid the common reset error?

Power off and unplug the projector, let it cool, open the lamp door, remove the old module, insert the new SP-LAMP-006 until it clicks, close the door, then hold the reset button while powering on to clear the hour counter.

When should I plan to replace the UHP 250W bulb based on the rated lifespan?

The lamp is rated for 2000 hours of typical use; schedule a replacement once the projector timer approaches that figure or when brightness noticeably drops.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.